IBM PPC-1510PT user manual Material

11.Cautions

1.Application : This specification is applied to 6wire Touch Panel.

2.Warranty : TOUCH PANEL products manufactured to this specification shall be capable of meeting all characteristics for a minimum period of 12 months the date of shipping from NAGASAKI IPC when stored or used as specified under normal conditions within the contents of these sheets. If TOUCH PANEL products are not stored or used as specified herein, it will be void the 12 months warranty.

3.Features

Type Analog Resistive Type Touch Panel
Input Mode	Polyester Pen or Finger
Structure	Film----- ITO Film Glass----ITO Glass
4. Characteristics
4.1 Operating Temperature Range : From –20		to 60 (Humidity 90%RH or lower, no dew condition shall be
acceptable)
4.2 Storage Temperature Range : From –30		to 70
(Humidity 90%RH or lower, no dew condition shall be acceptable)
4.3 Input Method

(1) with Polyester Pen

Operation and measurement with a pen must be carried out under the following trip condition

Material	Polyester		Tip SR 0.8 millimeter
(2) with Finger
Operation and measurement with a finger must be carried out under the
Material	Silicon rubber (Hardness: 60ºHs)			Tip SR 12.5 millimeter
5. Electrical Specifications
5.1 Linearity	Direction ± 1.5% or less (with calibration controller)
5.2 Insulation Resistance			20 MO or more @ DC 25V
5.3 Chattering Time		10 millisecond or less @ 100KO
6. Mechanical Specifications			Item No. Item Ratings Test Methods & Condition
6-1 Operating Force		with Polyester Pen SR 0.8

According to applicable product specification Less than 150g Using a load cell with a Polyester Pen conforming to the specifications set forth in item 4.3 (1) attached to its tip, apply a vertical load within the valid area.

Using themeasurement circuit illustrated in diagram 6-1 below, take the gauge value when the voltage value 4.5V or greater as the pressure load value.

6-2 Surface Hardness : 2H or Higher JIS-K5400

- 6 -