Fujitsu P2000 manual Hard Drive Problems, Push the Suspend/Resume/Power On button

		T r o u b l e s h o o t i n g
Problem	Possible Cause	Possible Solutions
The DVD/CD-RW Access	The Windows DVD/CD-RW	This is normal. However, you may disable this
indicator on the Status	auto insertion function is	feature. (See Auto Insert Notification Function on
Indicator Panel blinks at	active and is checking to see if	page 38 for more information)
regular intervals when no	a DVD/CD-RW disc is ready to
DVD/CD-RW disc is in the	run.
tray or the drive is not
installed.
Floppy Disk Drive Problems
You cannot access your	You tried to write to a write	Eject the floppy disk and set it to write enable. (See
floppy disk.	protected floppy disk.	Preparing a Disk for Use on page 44 for more informa-
		tion)
	Floppy disk is not	Eject floppy disk, check orientation and re-insert.
	loaded correctly.	(See Ejecting a Disk on page 44 for more information)
	BIOS setup utility states	Revise the setup utility Main menu settings to
	Diskette Controller:	enable Diskette Controller. (See BIOS Setup Utility
	Disabled.	on page 27 for more information)
	The floppy disk drive may not	Remove and re-install your floppy disk drive.
	be properly installed.
	Security is set to protect access	Verify your password and security settings.
	to floppy disk data.
Hard Drive Problems
You cannot access your	The setup utility is incorrectly	Revise BIOS settings to set both Primary Master
hard drive.	set for your internal (Primary	and Primary Slave correctly. (See BIOS Setup Utility
	Master) or optional second	on page 27 for more information)
	hard drive (Primary Slave).
	The wrong drive designator	Verify drive designator used by application is in
	was used by an application	use by the operating system. When the operating
	when a bootable CD-ROM was	system is booted from a CD, drive designations
	used to start the notebook.	are automatically adjusted.
	Security is set so your oper-	Verify your password and security settings.
	ating system cannot be started
	without a password.
Keyboard or Mouse Problems
The built-in keyboard does	The notebook has gone into	Push the Suspend/Resume/Power On button.
not seem to work.	Suspend mode.
	Your application has locked	Try to use your integrated pointing device to restart
	out your keyboard.	your system. If this fails, turn your notebook off
		using the Power Off button located on the back of
		the system. Wait 10 seconds or more, and then turn
		the system back on.
You have installed an	Your external device is not	Re-install your device. (See Device Ports on page 43
external keyboard or	properly installed.	for more information)
mouse, and it does not
	Your operating system	Check your device and operating system docu-
seem to work.
	software is not setup with the	mentation and activate the proper driver.
	correct software driver for that
	device.

67