L i f e B o o k P 2 0 0 0 N o t e b o o k – S e c t i o n S i x
Problem | Possible Cause | Possible Solutions | |
|
|
| |
|
|
| |
You have connected an | Your operating system | Check your device and operating system | |
external keyboard or a | software is not setup with | documentation and activate the proper driver. | |
mouse and it seems to be | the correct software driver |
| |
locking up the system. | for that device. |
| |
|
|
| |
| Your system has crashed. | Try to restart your notebook. If that fails, turn off | |
|
| the power using the Power Off button located on the | |
|
| back of the system. Wait 10 seconds or more, and | |
|
| then turn the system back on. | |
|
|
| |
When the system is slightly | This happens due to the design | If this occurs, wait until the cursor stops moving; it | |
inclined and the Quick- | specifications of the Quick | should then work properly. | |
Point device has been | Point device. |
| |
worked with slowly for |
|
| |
several seconds, the cursor |
|
| |
slowly moves across the |
|
| |
screen when you are not |
|
| |
using it. |
|
| |
|
|
| |
Memory Problems |
|
| |
|
|
| |
Your Power On screen, or | Your memory upgrade module | Remove and | |
Main menu of the BIOS | is not properly installed. | module. (See Memory Upgrade Module on page 40 | |
setup utility information, |
| for more information) | |
does not show the correct |
|
| |
You have a memory failure. | Check for Power On Self Test (POST) messages. | ||
amount of installed | |||
| (See Power On Self Test Messages on page 74 for more | ||
memory. |
| ||
| information) | ||
|
| ||
|
|
| |
Modem Problems |
|
| |
|
|
| |
Messages about modem | Messages about modem | See your application software documentation for | |
operation. | operation are generated by | additional information. | |
| whichever modem application |
| |
| is in use. |
| |
|
|
| |
USB Device Problems |
|
| |
|
|
| |
You have installed a USB | The device is not properly | Remove and | |
device but your LifeBook | installed. | on page 43 for more information) | |
notebook does not recog- |
|
| |
The device may have been | Close the application and restart your notebook. | ||
nize the device, or the | |||
installed while an application |
| ||
device does not seem to |
| ||
was running, so your notebook |
| ||
work properly. |
| ||
is not aware of its installation. |
| ||
|
| ||
|
|
| |
| Your software may not have | See your software documentation and activate the | |
| the correct software driver | correct driver. | |
| active. |
| |
|
|
| |
| You may have the wrong I/O | See your device documentation and software docu- | |
| address selected for your | mentation to determine the required I/O address. | |
| device. | Change the settings in the BIOS setup utility. (See | |
|
| BIOS Setup Utility on page 27 for more information) | |
|
|
| |
| Your device and another | Check all I/O addresses located within the BIOS | |
| device are assigned the same | setup utility and any other installed hardware or | |
| I/O address. | software to make sure there are no duplications. | |
|
|
|
68