Fujitsu B3020D manual Power on Self Test Messages

Page 68

POWER ON SELF TEST MESSAGES

The following is an alphabetic list of error-and-status messages that Phoenix BIOS and/or your operating system can generate and an explanation of each message. Error messages are marked with an *. If an error message is displayed that is not in this list, write it down and check your operating system documentation both on screen and in the manual. If you can find no reference to the message and its meaning is not clear, contact your support representative for assistance.

nnnn Cache SRAM Passed

Where nnnn is the amount of system cache in kilobytes successfully tested by the Power On Self Test. (This can only appear if you have an SRAM PC Card installed.)

*Diskette drive A error or Diskette drive B error

Drive A: or B: is present but fails the BIOS Power On Self Test diskette tests. Check to see that the drive is defined with the proper diskette type in the Setup Utility, See “BIOS Setup Utility” on page 29. and that the diskette drive is installed correctly. If the disk drive is properly defined and installed, avoid using it and contact your support representative.

*Extended RAM Failed at offset: nnnn

Extended memory not working or not configured prop- erly. If you have an installed memory upgrade module, verify that the module is properly installed. If it is prop- erly installed, you may want to check your Windows Setup to be sure it is not using unavailable memory until you can contact your support representative.

nnnn Extended RAM Passed

Where nnnn is the amount of memory in kilobytes successfully tested.

*Failing Bits: nnnn The hex number nnnn

This is a map of the bits at the memory address (in System, Extended, or Shadow memory) which failed the memory test. Each 1 (one) in the map indicates a failed bit. This is a serious fault that may cause you to lose data if you continue. Contact your support representative.

*Fixed Disk x Failure or Fixed Disk Controller Failure (where x = 1-4)

The fixed disk is not working or not configured prop- erly. This may mean that the hard drive type identified in your setup utility does not agree with the type detected by the Power On Self Test. Run the setup utility to check for the hard drive type settings and correct them if necessary. If the settings are OK and the message appears when you restart the system, there may be a serious fault which might cause you to lose data if you continue. Contact your support representative.

T r o u b l e s h o o t i n g

*Incorrect Drive A type – run SETUP

Type of floppy drive A: not correctly identified in Setup. This means that the floppy disk drive type identified in your setup utility does not agree with the type detected by the Power On Self Test. Run the setup utility to correct the inconsistency.

*Incorrect Drive B type – run SETUP

Type of floppy drive B: not correctly identified in Setup. This means that the floppy disk drive type identified in your setup utility does not agree with the type detected by the Power On Self Test. Run the setup utility to correct the inconsistency.

*Invalid NVRAM media type

Problem with NVRAM access. In the unlikely case that you see this message you may have some display prob- lems. You can continue operating but should contact your support representative for more information.

*Keyboard controller error

The keyboard controller test failed. You may have to replace your keyboard or keyboard controller but may be able to use an external keyboard until then. Contact your support representative.

*Keyboard error

Keyboard not working. You may have to replace your keyboard or keyboard controller but may be able to use an external keyboard until then. Contact your support representative.

*Keyboard error nn

BIOS discovered a stuck key and displays the scan code for the stuck key. You may have to replace your keyboard but may be able to use an external keyboard until then. Contact your support representative.

*Monitor type does not match CMOS – Run SETUP

Monitor type not correctly identified in Setup. This error probably means your BIOS is corrupted, run the setup utility and set all settings to the default conditions. If you still get this error, contact your support represen- tative.

*Operating system not found

Operating system cannot be located on either drive A: or

drive C: Enter the setup utility and see if both the fixed

disk, and drive A: are properly identified and that the boot sequence is set correctly. Unless you have changed your installation greatly, the operating system should be on drive C:. If the setup utility is correctly set, your hard drive may be corrupted and your system may have to be re-installed from your back up media.

61

Page 67 Page 69
Image 68
Page 67 Page 69
Contents Fujitsu LifeBook Series Copyright Declaration of ConformityF e B o o k B S e r i e s Table of Contents Troubleshooting Glossary F e B o o k B S e r i e s Preface F e B o o k B S e r i e s Warranty PrefaceAbout this Guide Fujitsu Contact InformationF e B o o k B S e r i e s S e c t i o n O n e Getting to Know Your LifeBook F e B o o k B S e r i e s Overview UnpackingTOP and Front Components LEFT-SIDE Panel Components DC Power Jack RIGHT-SIDE Panel ComponentsUSB 2.0 Ports Modem RJ-11 Telephone PortBottom Components Rear Panel Components Anti-theft Lock SlotStatus Indicator Panel Power IndicatorAC Adapter Indicator Battery Level IndicatorsCompact Flash CF Card Access Indicators Battery Charging IndicatorPC Card Access Indicators Numlk IndicatorKeyboard F e B o o k B S e r i e s S e c t i o n T w o Dragging ClickingDOUBLE-CLICKING Touchpad Control Adjustment Touch ScreenClicking Double-ClickingRight-clicking Calibrating the Touch ScreenVolume Control Controlling the VolumeLifeBook Security Application Panel Setting UP Your Lifebook Security PanelPasswords Operating Your Lifebook SECURITY/ Application Panel PrecautionsUninstalling the Security Panel Application Reinstalling the Security/Application Panel Configuring your LifeBook Application PanelUser SupervisorDeactivating and Activating the LifeBook Application Panel Getting Started F e B o o k B S e r i e s Power Sources Connecting the Power AdaptersConnecting the Optional Auto/Airline Adapter Connecting the AC AdapterAdjusting Display Panel Brightness Display PanelOpening the Display Panel Closing the Display PanelPower on Boot SequenceBios Setup Utility Starting Your LifeBook NotebookBooting the System Activating Additional UtilitiesHow do I register? Registering Your Lifebook NotebookWhat are the benefits of registering? SUSPEND/RESUME Button Power ManagementStandby Mode Hibernate Mode Display TimeoutHard Disk Timeout Windows Power ManagementProcedure Power OFFClick OK. Your notebook will shut down and then reboot User-Installable Features F e B o o k B S e r i e s Recharging the Batteries Lithium ion BatteryLow Battery State Cold-swapping Batteries Replacing the BatteryShorted Batteries Connecting AN Optional External Floppy Disk Drive External Floppy Disk DriveLoading a Disk Ejecting a DiskFloppy Disk Write Protect Installing PC Cards PC CardsRemoving PC Cards Smart Card ReaderSteps Figure Installing Compact Flash CardsCompact Flash Cards Removing Compact Flash Cards To remove a Compact Flash Card, follow these easy StepsRemoving a Memory Upgrade Module Installing a Memory Upgrade ModuleChecking the Computer Recognition NEW Memory Capacity Replace the cover Replace the screwPort Replicator Front Panel Components Attaching the Port ReplicatorDetaching the Port Replicator Docking PortDevice Ports Docking Port Universal Serial BUS 2.0 PortsMicrophone Jack Headphone JackF e B o o k B S e r i e s S e c t i o n F o u r Troubleshooting F e B o o k B S e r i e s Troubleshooting Identifying the ProblemSpecific Problems Using the Troubleshooting TableTroubleshooting Table ProblemAudio Problems Port Replicator ProblemsMemory Problems Hard Drive ProblemsKeyboard or Mouse Problems Modem Problems Parallel, Serial, and USB Device ProblemsBios Setup Utility on PC Card ProblemsPower Failures Power Sources onResume button. See Power Sources on Battery. See Status Indicator Panel onShutdown and Startup Problems An error message isSee the Power On Self Test Post messages to Indicators. See Power On Self Test Messages on8 for location Video ProblemsTion needs. See Bios Setup Utility on Display goes blank by Power management time Menu of the BIOS. See Bios Setup Utility onMiscellaneous Problems Your external monitor is notPower on Self Test Messages Modem Result Codes Drivers and Applications Restore DAR CD contains Creating a Backup ImageCreating a backup image when booting up Drive Image Special Edition DiseAutomatically Downloading Driver Updates Enlarging the Backup PartitionRestoring a Backup Image Re-Installing Individual Drivers and ApplicationsCare and Maintenance F e B o o k B S e r i e s Keyboard Care and MaintenanceLifebook Notebook Batteries Floppy Disks and DrivesCaring for your PC Card Slots PC CardsCaring for your CD-ROM Drive F e B o o k B S e r i e s S e c t i o n S i Specifications F e B o o k B S e r i e s Specifications Power Dimensions and WeightPopular Accessories Theft Prevention Lock SlotPRE-INSTALLED Software Learning about Your Application SoftwareF e B o o k B S e r i e s S e c t i o n S e v e n Glossary F e B o o k B S e r i e s Glossary Default Value DiskDisk Drive DisketteLithium ion Battery IeeeInfrared InfrastructureReset Operating SystemPartition Peripheral DeviceStatus Indicator Wi-Fi CompatibleStandby Stereo audioRegulatory Information FCC NoticesAvis Aux Utilisateurs Du Réseau Téléphonique Canadien UL Notice AC Adapter output polarityFor Authorized Repair Technicians Only System DisposalAppendix Optional DeviceF e B o o k B S e r i e s FCC Regulatory Information Before Using the Wireless LAN Wireless LAN Modes Using this DeviceWireless LAN Devices Covered by this Document Characteristics of the Wlan DeviceWireless Network Considerations Access Point Infrastructure ModeHow to Handle This Device Deactivation using the Wireless On/Off SwitchActivating the Wlan Device Deactivation using the Intel PROSet SoftwareDeactivation using Atheros Client Utility software Flow of Operations Configuration of the Wlan DeviceProcedure Configuration Using Intel Proset Software Configuration Using Atheros Client Utility Software Field Name Description Setting the network Setting TCP/IPSetting the sharing function Connection to the NetworkSetting the printer-sharing function Setting the Microsoft network-sharing serviceSetting the file-sharing function Confirming connection Confirming the status of the radioConnection UnavailableNetwork Wireless LAN Glossary Shared key authentication Ssid Service Set IdentifierWi-Fi Subnet maskIP address information Specification BatteryAid Boot Boot Sequence Cache Memory CapsLock Indicator CardBusFujitsu Driver Update utility Function Key FDU Floppy DiskHard Disk Drive LAN RJ-45 Jack LifeBookPorts Post Power Power Management Power On Self Test Power specificationsSecurity Indicator Video Volume controlWireless LAN WFM Windows End user license agreement
Top Page Image Contents