DANGER
Electrical current from power, telephone, and communication cables is hazardous.
To avoid a shock hazard:
—Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this product during an electrical storm.
—Connect all power cords to a properly wired and grounded electrical outlet.
—Connect to properly wired outlets any equipment that will be attached to this product.
—When possible, use one hand only to connect or disconnect signal cables.
—Never turn on any equipment when there is evidence of fire, water, or structural damage.
—Disconnect the attached power cords, telecommunications systems, networks, and modems and modems before you open the device covers, unless instructed otherwise in the installation and configuration procedures.
—Connect and disconnect cables as described in the following table when installing, moving, or opening covers on this product or attached devices.
To connect: | To disconnect: | ||
1. | Turn everything OFF. | 1. | Turn everything OFF. |
2. | First attach all cables to devices. | 2. | First, remove power cords from outlet. |
3. | Attach signal cables to connectors. | 3. | Remove signal cables from connectors. |
4. | Attach power cords to outlet. | 4. | Remove all cables from devices. |
5. | Turn device ON. |
|
|
|
|
|
|
Starting the projector and adjusting the image
Use the following procedure to start the projector and adjust the image.
Note: Always use the power cord that comes with the projector.
1.Remove the lens cap.
2.Plug the power cord into the side of the projector, and then plug it into an electrical outlet. A
Note: The first time you connect your computer to the projector, the computer might display a message stating that new hardware was
Installation and user’s guide |