iLV200/iLC200 IBM Data/Video Projector: User’s Guide
The distance from the lens of the projector to the screen and the zoom setting determine the size of the projected image. The following illustration shows three projected image sizes. For more information about image size, see Appendix D, ″Projected image size,″ on page 15.
2.
Position the projector the desired distance from the screen. v
v Avoid leaving the projector in direct sunlight or extreme cold for extended periods of time. If this happens, allow it to reach room temperature before use.
v Transport the projector in a carrying case. Refer to Appendix A to determine what accessories are available for your projector.
Setting up the projector
Use the following procedure to set up the projector:
1. Place the projector on a flat surface.
v The projector must be within 10 feet (3 m) of your power source and within 6 ft. (1.8 m) of your computer.
v If you want to project from behind a translucent screen, set up the projector behind the screen. See “Rear projection” on page 1-22 for instructions for reversing the image.
Attention: Do not look directly into the projection lens when the lamp is turned on. The bright light might harm your eyes.
Attention: Do not block the grills on the projector. Restricting the airflow can cause it to overheat and turn off. If this happens, you must wait a minute before attempting to turn it back on.
vHandle the projector as you would any product with glass components. Be especially careful not to drop it.