IBM ILV200, ILC200 manual Replacing the batteries in the remote control

6.Grasp and lift the pull tab and lift the module out. Dispose of the lamp module in an environmentally proper manner.

WARNING:

Do not drop the lamp module or touch the glass bulb. The glass might shatter and cause injury.

7.Install the new lamp module, being sure to align the connectors properly.

8.Push the module in until it is flush with the bottom case of the projector.

9.Tighten the screws on the outside of the module.

10.Replace the lamp-module door by inserting the hooks on the rear of the lamp-module door into the projector and pressing the lamp-module door into place. If the lamp-module door does not fit properly or bulges out, remove the door and reseat the lamp module.

11.Plug in the power cord to turn the projector back on.

12.To reset the lamp-hour counter in the Status window, press and hold the volume - button, then press the menu button (while still holding down the volume - button) for 5 seconds. Verify that the counter was reset by pressing the menu button and viewing the counter in the Status window.

Replacing the batteries in the remote control

The life of the batteries depends on how often and how long you use the remote control. Symptoms of low battery charge include erratic responses when you use the remote control and a reduced range of operation.

Follow these steps to replace the batteries:

1.Turn the remote control face down in your hand.

2.Slide the battery cover off the end of the remote control.

3.Remove the old batteries and dispose of them in an environmentally proper manner.

1-28iLV200/iLC200 IBM Data/Video Projector: User’s Guide