IBM ILC200, ILV200 manual Standby, Volume keypad only, Using the on-screen menus

Source (keypad only) or computer and video (remote control only)

When you have more than one source (computer and video) connected to the projector, select between them by pressing the source button on the keypad or the computer or video button on the remote control.

Standby

When you press the standby button, the display and audio turn off and a blank screen is displayed for 15 minutes. You can change the amount of time the projector stays in standby mode; see “Standby time” on page 1-22for details.

vIf you press the standby button again within 15 minutes, the projector returns to operation immediately.

vIf you press standby again after 15 minutes, there is approximately a 60-second delay before the lamp turns back on.

vIf you do not press standby again, the lamp turns off after 15 minutes.

Volume (keypad only)

power

menu

source

volume - volume +

standby

To increase the volume, press the volume + button. To decrease the volume, press the volume - button.

Volume adjustments are saved for each source that you have connected.

Using the on-screen menus

The projector has six drop-down menus that you can use to make image adjustments and change a variety of settings. Most of these adjustments are not available directly from the keypad.

Note: Some menu items might be unavailable at certain times. This indicates

that the item is not applicable to your setup (for example, video standards do not apply to computer sources) or the item is not enabled

Installation and user’s guide 1-15