Procedures
1. Did the message “No Adapter Card Found” appear?
No Continue at step 3.
Yes Continue at step 2.
2. Check the following to isolate the problem. Run the program after each step to see if the problem i
a. Make sure that the card is fully seated in th slot.
b. Refer to the “Installation Instructions” on page that the card (and the initialization file if operating system) are installed correctly.
c. If the problem still persists, have the card Appendix A on page 23).
3.Did Xan appear beside any of the following three display items?
ŸI/O
ŸMemory
ŸInterrupt
No Continue at step 5 on page 16.
Yes Continue at step 4.
4. Check the following to isolate the problem. Run the program after each step to see if the problem i
a. Make sure that the system BIOS code is curren
| Note: If | it is | not | the most current version, obt | |
current | version | and | load it | onto your system. Fo | |
on revising and upgrading BIOS for IBM PCs, go | |||||
http://www.pc.ibm.com/support | on the World Wide W | ||||
information. |
|
|
| ||
b.The following is an optional step if a vacant available in the system unit:
Section 2. The 3270 PCI Card for Personal Computers with15 PCI