Fujitsu D2529 technical manual Batteries

Page 8

Notes on safety

Important notes

V● Components can become very hot during operation. Ensure you do not touch components when making extensions to the system board. There is a danger of burns!.

●Transmission lines to peripheral devices must be adequately shielded.

●To the LAN wiring the requirements apply in accordance with the standards EN 50173 and EN 50174-1/2. As minimum requirement the use of a protected LAN line of category 5 for 10/100 MBps Ethernet, and/or of category 5e for Gigabit Ethernet is considered. The requirements of the specification ISO/IEC 11801 are to be considered.

●Never connect or disconnect data transmission lines during a storm (lightning hazard).

Batteries

VCAUTION!

●Incorrect replacement of lithium battery may lead to a risk of explosion. The batteries may only be replaced with identical batteries or with a type recommended by the manufacturer.

It is essential to observe the instructions in chapter “Replacing the lithium battery”.

8

Technical Manual

D2529 (TX300 S4)

Image 8

Contents System Board D2529 for TX300 S4 Comments… Suggestions… Corrections… Certified documentation according to DIN EN ISOContents Page Introduction Notational conventionsPage Important notes Batteries ESD label CE Certificate CE CertificateEnvironmentally friendly product design and development Environmental ProtectionImportant notes Environmental Protection Returning, recycling and disposalFeatures OverviewProcessors Main memoryInternal connectors External connectorsOverview PCI slotsFeatures Bios featuresCSS Customer Self Service Form factorOverview Main memory Slots for riser cardsDimm C/D Module populationNon-mirrored mode Mirrored modeRiser card A/B Riser card C/D Alternating PopulationPCIe slots Sparing modePCIe slots PCI slot Bit Frequency Description MHz PCI, PCI-X, PCI Express interruptsSlot/device Property Interruptsignal Assignment of the PCI interruptsScreen resolution Temperature / system monitoringScreen resolution Max. color depth Max. frequency Temperature monitoringTemperature / system monitoring Primergy Diagnostic LEDsFan speed control Sensor monitoringLEDs LEDsLED Anzeige BedeutungCPU Interfaces and connectors Interfaces and connectors= SATA4 External ports LAN connectors LAN connector single-channel Gigabit LAN controllerRecovering System Bios recovery switch switch Settings with DIP switchesSettings with DIP switches Write protection for floppy disks switch Skipping the password query switchWrite protection for Flash Bios switch Settings with DIP switches Replacing the lithium battery Replacing the lithium batteryPage Abbreviations Abbreviations IRMC ISCSIPDA WfM