Fujitsu D1931 technical manual Pin assignment of internal ports, Front panel

Page 22

HD-LED

Pin assignment of internal ports

Pin assignment of internal ports

The pin assignment of some internal connections is shown in English in the following.

i	Some of the following connectors may be optional!

Front panel

Power On/Off1) Message LED

Watch the poling of the LEDs. The positive pole of the connection cables is often indicated with a coloured wire.

Reset

Power On

LED 2)

1

2

Recovery Password

1)Both connector positions possibleSpeaker

2)2pin or 3pin connector possible

Connection	Note

Reset	Connector for reset switch
Power On/Off	Connection for ATX On/Off switch
HD LED	Indicates HDD (hard disk) activity
Message LED	Indicates system management error
Power On LED	Indicates the system state APM or ACPI together with the Sleep LED (see
	chapter entitled "APM and ACPI system status, energy-saving modes").
Recovery	see "Jumper settings" chapter
Password	see "Jumper settings" chapter
Speaker	0,5 W at 8 Ohm

12 - English

A26361-D1931-Z120-1-7419, Edition 1

Image 22

Contents

Answers Deutsch / EnglishSie haben Page A26361-D1931-Z120-1-7419 Technisches Handbuch Technical Manual Mainboard D1931Ausgabe Mai May 2004 edition Page Übersicht/Overview Mainboard D1931 Externe Anschlüsse / External connectorsBedienfeld / Front panel Page Contents Page Notational conventions Additional informationImportant notes Information about boardsSpecial onboard features List of featuresOnboard features Internal portsExternal ports Special features Safe Standby Prior to installation Brief instructions on installing mainboardInstallation Driver installation Brief instructions on installing mainboard LAN connector Interfaces and connectors External ports Screen resolution Internal ports and connectorsTechnical data Graphics portAudio front panel Pin assignment of internal ports Front panelSerial ATA ATA interface Audio S/PDIFAudio Input Power control system monitoringAudio port front USB dual channel Chipcard reader ready Fan 1, 2Power supply BTX Additional power supply ATX12Skipping system and Bios Setup password pinpair a Jumper settingsSetting via control-panel plug connector Recovering System Bios pinpair BAdd-on modules / Upgrading Installing processor with heat sinkReplacing processor Replacing processor Mounting heat sink Upgrading main memory Installing a memory module Removing a memory modulePCI bus interrupts Selecting correct PCI slot Adding PCI Express cardsAdding PCI cards Monofunctional expansions cardsPCIe USB 2,0 SMBus Audio On board controllerAC97 USB 1,1 PCI slot AC97 HD AudioReplacing the lithium battery When should a Bios update be carried out? Bios updateBios update under Windows with DeskFlash utility Bios Recovery Recovering System Bios What is a microcode update? Microcode UpdateWhen should a microcode update be carried out? Drivers Loadability for connections and fuses AnnexElectrical Properties Mainboard current requirementAPM and Acpi system status, energy-saving modes APM and Acpi system status, energy-saving modesBios version Mainboard Revision and Bios VersionMainboard Revision Error messages Bios update for installed CPU failedError messages Monitor type does not match Cmos RUN Setup System battery is dead Replace and run Setup Glossary SimdGlossary