Fujitsu D1931 technical manual Error messages, Bios update for installed CPU failed

Page 44

Error messages

This chapter contains error messages generated by the mainboard.

Available CPUs do not support the same bus frequency - System halted! Memory type mixing detected

Non Fujitsu Siemens Memory Module detected - Warranty void There are more than 32 32 RDRAM devices in the system

Check whether the system configuration has changed. If necessary, correct the settings.

BIOS update for installed CPU failed

This message appears if the microcode update required for the connected processor is not contained in the system BIOS.

Boot the system with the inserted Flash BIOS floppy disk.

Abort the normal Flash BIOS update by answering the question about whether you want to perform the update with

n

To carry out the Flash BIOS update for the processor, enter:

flashbio└┘/p6

Check date and time settings

The system date and time are invalid. Set the current date and time in the Main menu of the BIOS Setup.

CPU ID 0x failed

Switch the server off and on again. If the message is still displayed, go into the BIOS setup and set the corresponding processor to Disabled in the Server - CPU Status menu; please contact your sales outlet or customer service centre.

CPU mismatch detected

You have replaced the processor or changed the frequency setting. As a result, the characteristic data of the processor have changed. Confirm this change by running the BIOS Setup and exiting it again.

Diskette drive A error

Diskette drive B error

Check the entry for the diskette drive in the Main menu of the BIOS Setup. Check the connections to the diskette drive.

34 - English

A26361-D1931-Z120-1-7419, Edition 1

Image 44
Contents Answers Deutsch / EnglishSie haben Page A26361-D1931-Z120-1-7419 Ausgabe Mai May 2004 edition Mainboard D1931Technisches Handbuch Technical Manual Page Bedienfeld / Front panel Externe Anschlüsse / External connectorsÜbersicht/Overview Mainboard D1931 Page Contents Page Notational conventions Additional informationImportant notes Information about boardsList of features Onboard featuresSpecial onboard features Internal portsExternal ports Special features Safe Standby Installation Brief instructions on installing mainboardPrior to installation Driver installation Brief instructions on installing mainboardExternal ports Interfaces and connectorsLAN connector Internal ports and connectors Technical dataScreen resolution Graphics portAudio front panel Pin assignment of internal ports Front panelSerial ATA ATA interface Audio S/PDIFAudio port front Power control system monitoringAudio Input USB dual channel Chipcard reader ready Fan 1, 2Power supply BTX Additional power supply ATX12Jumper settings Setting via control-panel plug connectorSkipping system and Bios Setup password pinpair a Recovering System Bios pinpair BReplacing processor Installing processor with heat sinkAdd-on modules / Upgrading Replacing processor Mounting heat sink Upgrading main memory Installing a memory module Removing a memory moduleAdding PCI Express cards Adding PCI cardsPCI bus interrupts Selecting correct PCI slot Monofunctional expansions cardsOn board controller AC97 USB 1,1 PCI slotPCIe USB 2,0 SMBus Audio AC97 HD AudioReplacing the lithium battery Bios update under Windows with DeskFlash utility Bios updateWhen should a Bios update be carried out? Bios Recovery Recovering System Bios When should a microcode update be carried out? Microcode UpdateWhat is a microcode update? Drivers Annex Electrical PropertiesLoadability for connections and fuses Mainboard current requirementAPM and Acpi system status, energy-saving modes APM and Acpi system status, energy-saving modesMainboard Revision Mainboard Revision and Bios VersionBios version Error messages Bios update for installed CPU failedError messages Monitor type does not match Cmos RUN Setup System battery is dead Replace and run Setup Glossary SimdGlossary