Fujitsu D1931 technical manual System battery is dead Replace and run Setup

Page 47

Error messages

System battery is dead - Replace and run SETUP

Replace the lithium battery on the mainboard and redo the settings in the BIOS Setup.

System Cache Error - Cache disabled

Switch the device off and on again. If the message is still displayed, please contact your sales outlet or customer service centre.

System CMOS checksum bad - - Default configuration used

Call the BIOS Setup and correct the previously made entries or set the default entries.

System Management Configuration changed or Problem occurred

A system fan or system sensor has failed. Check the hardware operation.

System timer error

Switch the device off and on again. If the message is still displayed, please contact your sales outlet or customer service centre.

Uncorrectable ECC DRAM error

DRAM Parity error

Unknown PCI error

Switch the device off and on again. If the message is still displayed, please contact your sales outlet or customer service centre.

Verify CPU frequency selection in Setup

The frequency setting for the processor is invalid. Correct the BIOS Setup and the setting.

A26361-D1931-Z120-1-7419, Edition 1

English - 37

Image 47

Contents Deutsch / English AnswersSie haben Page A26361-D1931-Z120-1-7419 Ausgabe Mai May 2004 edition Mainboard D1931Technisches Handbuch Technical Manual Page Bedienfeld / Front panel Externe Anschlüsse / External connectorsÜbersicht/Overview Mainboard D1931 Page Contents Page Additional information Notational conventionsInformation about boards Important notesInternal ports List of featuresOnboard features Special onboard featuresExternal ports Special features Safe Standby Installation Brief instructions on installing mainboardPrior to installation Brief instructions on installing mainboard Driver installationExternal ports Interfaces and connectorsLAN connector Graphics port Internal ports and connectorsTechnical data Screen resolutionAudio front panel Front panel Pin assignment of internal portsSerial ATA Audio S/PDIF ATA interfaceAudio port front Power control system monitoringAudio Input Fan 1, 2 USB dual channel Chipcard reader readyAdditional power supply ATX12 Power supply BTXRecovering System Bios pinpair B Jumper settingsSetting via control-panel plug connector Skipping system and Bios Setup password pinpair aReplacing processor Installing processor with heat sinkAdd-on modules / Upgrading Replacing processor Mounting heat sink Upgrading main memory Removing a memory module Installing a memory moduleMonofunctional expansions cards Adding PCI Express cardsAdding PCI cards PCI bus interrupts Selecting correct PCI slotAC97 HD Audio On board controllerAC97 USB 1,1 PCI slot PCIe USB 2,0 SMBus AudioReplacing the lithium battery Bios update under Windows with DeskFlash utility Bios updateWhen should a Bios update be carried out? Bios Recovery Recovering System Bios When should a microcode update be carried out? Microcode UpdateWhat is a microcode update? Drivers Mainboard current requirement AnnexElectrical Properties Loadability for connections and fusesAPM and Acpi system status, energy-saving modes APM and Acpi system status, energy-saving modesMainboard Revision Mainboard Revision and Bios VersionBios version Bios update for installed CPU failed Error messagesError messages Monitor type does not match Cmos RUN Setup System battery is dead Replace and run Setup Simd GlossaryGlossary