IBM 4SB, 9TX, 9TS, 9QX, 9QS, 900, 4SA, 42P, 42X, 200, 42E On the rail marked R, loosen the four screws c2d

Note: Use clip nuts if your rack has holes. If your rack has square holes, you can use the rack-insertion tool or a flat-blade screwdriver to install cage nuts.

2.On the rail marked R, loosen the four screws c2d.

3.Hold the rail against the outside of the right rack-mounting flange, and loosely insert the two front M6 screws c1d.

4.Extend the rail outside of the rear rack-mounting flange; then, install and tighten two rear M6 screws c3d.

5.Tighten the two front screws c1d; then, tighten the four screws c2d.

Repeat step 2 through step 5 to install the rail marked L on the left side of the rack.

NetBAY 42 Enterprise Rack (Type 9308 Models 42P, 42X, 4SA, 4SB, 42S, 42E) 95