IBM 9TX, 9TS, 9QX, 9QS, 900, 4SB, 4SA, 42P, 42X, 200, 42E Server selector console, Server selector unit

Server selector console

To remove the Server Selector Console:

1.Power-off the rack.

2.Use an 1/8-inch allen wrench to remove screws.

3.Disconnect the server selector cable from the back of the server selector console.

4.Remove the server selector console from the cabinet.

Server

MonitorSelector

BezelConsole

Server	Server	Server
Selector
	Selector
		Selector
Keypad
	Electronics
		Cable

Server selector unit

The server selector unit is located in the upper rear of the rack cabinet. The server selector unit can only be accessed or removed from the rear of the IBM Rack cabinet.

CAUTION:

The server selector unit is heavy. You will need two people to safely remove the server selector unit. See “Safety notice (multi-lingual translations)” on page 191.

To remove the server selector unit:

1.Power-off the rack.

2.Unplug the keyboard, mouse, video cables, and the power cord.

3.Remove the server selector console.

4.With one person bracing the server selector unit from below, have the second person use a 5/16-inch wrench to remove the four nuts that secure the server selector unit to the rack cabinet.

5.Remove the server selector unit from the cabinet.

Note: When replacing the server selector unit, be sure that the Server Selector cable is fed through the indentation along the left side of the server selector unit.

6Hardware Maintenance Manual: IBM PC Server/Enterprise Racks