IBM 1116 manual Electronic emission notices, Industry Canada compliance statement

Page 113

Electronic emission notices

Federal Communications Commission (FCC) compliance information statement

Your printer has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

The FCC Class B limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult your point of purchase or service representative for additional suggestions.

The manufacturer is not responsible for any radio or television interference caused by using other than recommended cables or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void the user's authority to operate this equipment.

Note: To assure compliance with FCC regulations on electromagnetic interference for a Class B computing device, use a properly shielded and grounded cable. Use of a substitute cable not properly shielded and grounded may result in a violation of FCC regulations.

Industry Canada compliance statement

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

109

Argecy Computer Corporation 248-324-1800

Image 113

Contents User’s Reference Argecy Computer Corporation User’s Reference Argecy Computer Corporation Table of contents Loading labels Iii Argecy Computer Corporation About your printer Printer overviewUse this feature When you want to Operator panel has 6 lights and 1 operator panel button Using the operator panelArgecy Computer Corporation From the printer operator panel Canceling a print jobFrom a Windows computer From a Macintosh computerPrinting from a Windows environment Setting up a print jobArgecy Computer Corporation Printing from a Macintosh computer Choosing the right print media Media types and sizes Media Size Weight CapacityPrinter media sources Argecy Computer Corporation Tray Loading paperArgecy Computer Corporation Manual feed Argecy Computer Corporation Optional tray Corner bucklers Argecy Computer Corporation Loading transparencies Argecy Computer Corporation Manual feed Argecy Computer Corporation Loading envelopes Manual feed Argecy Computer Corporation Loading labels Argecy Computer Corporation Manual feed Argecy Computer Corporation Loading card stock Manual feed Argecy Computer Corporation Printing on both sides of the paper Short Edge means the pages are bound along the short edge Conserving supplies Removing the old print cartridge Replacing the print cartridgeInstalling the new print cartridge Fuser Clearing jams Remove the print cartridge it may be warm Argecy Computer Corporation Argecy Computer Corporation Reinstall the tray and resume printing Understandinglightsthe operator panel Argecy Computer Corporation Secondary error code Toner low Argecy Computer Corporation What this light sequence means Argecy Computer Corporation Argecy Computer Corporation Printer is flushing corrupted print data Argecy Computer Corporation Argecy Computer Corporation Print the other side of your duplex print job Argecy Computer Corporation Argecy Computer Corporation Printer flash memory is full Argecy Computer Corporation Printer memory is full Printer has received a page that is too complex to print Toner is low and the toner alarm is set to on Argecy Computer Corporation Argecy Computer Corporation Printer has a service error and printing has stopped Problem What to do Solving print quality problemsCartridge Printer or the computer Loading Paper From the special function menu, select Hex Trace mode to Using the special function menu Resetting user defaultsEnter the special function menu Restoring factory defaultsUsing Hex Trace mode Advanced troubleshooting mode Using print quality test pagesAdvanced troubleshooting Argecy Computer Corporation Factory default Argecy Computer Corporation Default Argecy Computer Corporation USB NPA Mode is set to Auto, the factory default Auto CRLF/LFCR is set to Off, the factory default Environments we support Setting up the network printerConnect the hardware Print a network setup Print Server TCP/IP Setup Utility Configure and printSet the IP address, netmask and gateway RequirementsStatic ARP entry and telnet TroubleshootingInstallation Print to a queue on a Windows NT server Set up to printPart 2 Create a Network Port Set up IP printing on Windows NT 4.0/2000Part 1 Install printer drivers and TCP/IP network support Set up IP printing on Windows 95/98/Me Part 2 Create a Network Port Part 1 Installing printer drivers and TCP/IP network support Install a shared printer on a Windows NT 4.0/2000 serverPart 3 Sharing the printer on the network Part 2 Creating a Network PortSetting up clients point and print Install a shared printer on network clientsSetting up clients peer-to-peer Novell NetWare Nprinter in IntraNetWare NDS Choosing NPRINTER/RPRINTER or PserverPserver in IntraNetWare NDS Advantages of using Pserver in NDSDisadvantage of using Pserver in NDS Pserver in NetWare Rprinter vs. Pserver in NetWareRprinter in NetWare AppleTalk Finding the default AppleTalk nameQueue-based printing Creating a desktop printer iconChanging the printer name Changing the zoneLaserWriter 8 environment prior to LaserWriter Updating printer hardwareLaserWriter 8 environment LaserWriter 8.4.1 and later QuickDraw GX environmentNormal conditions Print server light patterns Error conditions Trademarks Edition noticeSafety information Industry Canada compliance statement Electronic emission noticesAvis de conformité aux normes d’Industrie Canada German acoustics statementEuropean Community EC directives conformity Japanese Vcci notice United Kingdom Telecommunications ActLaser notice Dhcp Index113 114 Argecy Computer Corporation Part Number 53P9570