Fujitsu CELCIUS M/V/R Important notes, Safety notes, Transporting the device, Cleaning the device

Page 11

Important notes

In this chapter you will find information regarding safety which it is essential to take note of when working with your device.

Safety notes

Pay attention to the information provided in the "Safety" manual and in the following safety ! notes.

During installation and before operating the device, please observe the instructions on environmental conditions in the "Technical data" chapter as well as the instructions in the "Preparing for use" chapter.

The ON/OFF switch does not disconnect the device from the mains voltage. To completely disconnect the mains voltage, remove the power plug from the power socket.

The lithium battery on the mainboard should only be replaced in accordance with the instructions in the "Extensions to the mainboard" - "Battery: lithium battery: changing" chapter.

Caution, components in the system can get very hot.

Transporting the device

Transport all parts separately in their original packaging or in a packaging which protects ! them from knocks and jolts, to the new site. Do not unpack them until all transportation

manoeuvres are completed.

Cleaning the device

Turn off all power and equipment switches and disconnect the power plug from the mains ! outlet.

Do not clean any interior parts yourself, leave this job to a service technician. Do not use any cleaning agents that contain abrasives or may corrode plastic. Ensure that no liquid enters the system.

Wipe the casing with a dry cloth. If particularly dirty, use a cloth that has been moistened in mild domestic detergent and then carefully wrung out. Use disinfectant wipes to clean the keyboard and the mouse.

A26361-K990-Z120-1-7619, Edition 6

3

Image 11

Contents Celsius M / V / R Are there Page Published by Operating Manual Celsius M / V / RPage Contents Contents Documentation or Drivers & Utilities DVD Your CelsiusNotational conventions Transporting the device Safety notesCleaning the device Important notesCE mark for devices without radio component Energy saving, disposal and recyclingCE mark FCC Class B Compliance Statement Important notes External devices Steps for initial setupPreparing for use Unpacking and checking the deliveryScrewing on the base foot Celsius V, Celsius R6xx Setting up the deviceUnscrewing the base foot Celsius V, Celsius R6xx Connecting monitorConnect the monitor, mouse and keyboard Keyboard, connecting Connecting the mouseConnecting the device to the mains voltage Switching on monitor and device Switching on for the first time installing the softwareDisconnecting cables External devices, connectingInstalling the software Connecting cablesPorts provided by the device LANDevice drivers Connecting external devices to the parallel or serial portConnecting external devices to the USB ports Port settingsConnecting external devices to the FireWire port Operation Switching the device onSwitching off the device Power-on indicator Indicators provided by the deviceHard disk indicator Important keys and key combinations KeyboardMenu key Warm bootEnter key Start keyProtect the floppy disk against being overwritten or erased Working with floppy disksTo insert a floppy disk To remove a floppy diskAnti-theft protection Settings in Bios SetupProperty and data protection Anti-theft protection and lead-sealingMore information on SystemLock Bios setup security functionsAccess authorisation via SmartCard optional Access protection with SystemLock optionalSmartCard reader operating SystemLock permissionsTroubleshooting and tips Cause Troubleshooting TroubleshootingDevice cannot be switched off with the ON/OFF switch Screen, stays blank Set the correct values for the connected monitor, as No mouse pointer displayed on the screenTime and/or date is not correct Installing new softwareError messages on the screen Floppy disk cannot be read or writtenTips Hard disk contents, restoringInformation about boards System upgradesVariant a version with knurled screws Opening the casingVariant B version with a locking lever Closing the casing System upgrades Opening front panel Closing front panel Removing the side fan Installing the side fan Securing front fan on fan bracket Installing front fan Celsius MInstalling the front fan Removing front fan Celsius M Removing ventilation duct Celsius Installing ventilation duct Celsius Removing ventilation duct Celsius M System upgrades Installing ventilation duct Celsius M System upgrades Removing the ventilation duct Celsius R5xx Installing the ventilation duct Celsius R5xx Removing the cross-piece Installing the cross-piece Removing cover of power supply Celsius M Installing cover of power supply Celsius M Installing a board Installing and removing a boardSystem upgrades Removing a board Push the slot cover into the slot Removing slot adapter Low-profile boardsMounting slot adapter Serial ATA drives and Scsi drives Installing and removing drivesSata SCSI/SAS Removing an accessible drive System upgrades Installing an accessible drive Removing the floppy disk drive Floppy disk drive removing and installingInstalling the floppy disk drive Installing a hard disk drive Installing and removing the hard disk driveRemoving a hard disk drive System upgrades Screwing SmartCard reader onto carrier Installing/removing a SmartCard reader optionalSmartCard reader, installing SmartCard reader, installingSystem upgrades Removing a SmartCard reader System upgrades Initial installation of a Wlan module Installing and removing a Wlan module optionalInstalling Wlan module Installing Wlan module System upgrades Removing Wlan module Processor, replacing Extensions to the mainboardMain memory, upgrading Battery lithium battery changing System upgrades Electrical data Technical dataDimensions WeightTechnical data Cable IndexIndex Scsi USB