Adf | Fujitsu M3096EX/GX manual

Table 6.1 Check items (continued)

Problem	Possible cause	Response

The check	The carrier fixing bracket	Remove the carrier fixing bracket as
indicator is on.	was not removed.	explained in Section 3.2, “Removing the
		Carrier Fixing Bracket.”

	——————————	Turn the power off then on again. If the
		check indicator turns on again, contact the
		sales person in charge or a Fujitsu service
		representative.*

“Please clean	The pick roller is dirty.	When the power is turned off, the mes-
Pick-roller” is		sage is cleared.
displayed on the		Even if the message is displayed, the read
operator panel		operation can be continued. Clean the
during the read		pick roller after the read operation.
operation in the		(See Section 5.3.2.)
ADF.
ADF.	The unallowable document	If a document not meeting the scanner
Or check	The unallowable document	If a document not meeting the scanner
Or check	was read in the automatic	specifications is read in the automatic
indicator blinks	was read in the automatic	specifications is read in the automatic
indicator blinks	document feeder.	document feeder, the document is not fed
at four seconds	document feeder.	document feeder, the document is not fed
at four seconds	(See Section 4.3.)	smoothly and an error message may be
period.	(See Section 4.3.)	smoothly and an error message may be
period.		displayed.
		displayed.
		Read the document in the flat bed station.

Paper double feed	Pad is dirty.	Clean the Pad. (See Section 5.3.2)

	Pad is worn out.	Replace the pad. (See Section 5.4.2)

Miss pick	Pick roller is dirty.	Clean the Pick roller. (See Section 5.3.2.)

	Pick roller is worn out.	Replace the Pick roller.
		(See Section 5.4.3)

Paper jam	Some foreign particles are in	Clean the ADF (See Section 5.3.2) or
	ADF.	remove any foreign particles.

*Please chack the test mode in appendix B, if possible, before calling the service representa- tive and inform status of the indicators.

6 – 2

Table 6.1 Check items (continued)

ADF.