Fujitsu M3096EX/GX manual Table B.1 LED at an error

Page 49

(2)Activating the continuous operation test

Open the ADF and close it again. If no document is loaded on the ADF within five seconds after closing the ADF cover, the image scanner runs in flatbed mode. If docu- ments are loaded on the ADF within five seconds after closing the ADF cover, the image scanner continuously feeds the document from ADF. Once the image scanner start reading documents in the flatbed mode, it does not feed documents from ADF even if documents are loaded on the ADF.

(3)Ending the test in flatbed mode

To stop the carrier movement in flatbed mode, open the ADF cover. If the ADF cover is opened, the POWER lamp starts blinking immediately after the carrier returns to the home position.

(4)Ending the test in ADF mode

If the ADF document hopper is empty, feeding documents from the ADF ends. To restart feeding, open the ADF cover and close it again. Then load documents on the ADF docu- ment hopper within five seconds after closing the ADF cover.

(5)LED status on error

If an error occurs during the test, the LED indicates as shown in table B.1.

If paper is jammed in the ADF, remove the jam and close the ADF. The CHECK lamp stops blinking about three seconds after closing the ADF cover. To feed the document from ADF, open and close the ADF.

Table B.1 LED at an error

Errors/Alarm

POWER lamp

READ lamp

CHECK lamp

 

 

 

 

Paper jam

On

Off

Blink

 

 

 

 

Carrier drive alarm

Blink

Off

On

 

 

 

 

Optical system alarm

Blink

Off

Blink

 

 

 

 

Motor fuse failure

Blink

On

On

 

 

 

 

Lamp fuse failure

Blink

On

Blink

 

 

 

 

B – 2

Image 49
Contents Image Scanner OPERATOR’S Guide Revision Record Conventions Contents Maintenance Figures Tables Differences between the M3096EX and the M3096GX PrefaceThis page is intentionally left blank Checking the Components ComponentsExterior view of image scanner Part Names and FunctionsFunctions of each part Operator Panel Functions LCD model Indication Panel Functions standard modelButtons and liquid crystal display screen Liquid crystal display screen F aSize button Automatic document feeder ADF buttonDensity button Resolution buttonHalftone button Landscape buttonDocument button Mode 1 and 2 buttonP e r E m p t y Messages Error messages temporary errorsOperation status messages Error messages device errorsPrecautions Installation and ConnectionsRemoving the Carrier Fixing Bracket × ×Connections Page Mounting the Stacker SCSI-ID setting SCSI-ID SettingOperations Turning on the PowerReading a standard-size document Reading a Document in Flatbed ModeReading a page from a thick book Flatbed readingRemoving the document cover Reading a document larger than the document boardReading Documents in ADF Mode Section a enlargerd ADF paper chute setting Top For portrait mode Or less Loading the document This page is intentionally left blank Removing Jammed Documents MaintenanceCleaning Cleaning the ADF Parts number and replacement cycle Consumables/Periodical replacement partsReplacing pad ASY Replacing pick roller Pick Roller replacementMove the Retaining spring Check items Chapter TroubleshootingADF Table A.1 Installation specifications Installation SpecificationsAppendix a Figure A.1 External dimensions External DimensionsAppendix B Test mode for maintenanceTable B.1 LED at an error Appendix C IPC-2/CMP-2 option board installationOption Flat cable Flat cable connector Italy Reader Comment Form