IBM SENG-3002-01 manual Unit Covers, System Units

Page 21

Unit Covers

Locate the diagram of the unit you are working on. If you have a 270 system unit in a rack, go to “270 unit in a rack” on page 16.

270 and 820 System Units

To access the PCI card location, you need to remove the back cover and the side cover:

__ 1. Place your hand near the bottom of the back cover and lift up and out.

__ 2. Attention: If removing side cover while powered on, errors may occur due to electromagnetic interference.

Remove the right side cover (view from back) by loosening the thumbscrews and sliding the cover from front to back until it stops.

__ 3. Pull the cover out.

© Copyright IBM Corp. 2000, 2001

15

Image 21

Contents 30xx Memory Card Installation Page 30xx Memory Card Installation Second Edition May Laser Safety Information Safety and Environmental NoticesBattery Return Program Product Recycling and DisposalEnvironmental Design Before you begin Installation InstructionsIdentifying the memory location Powering off the system unitYes No ↓ Go to on Remove the empty card assembly Location of Card Assembly 2884 in 820 Unit Adding memory to the card assemblyMemory Locations on Card Assembly Install Memory Cards Installing memory cards inside your system unitMemory Connectors View Memory Connectors View No Yes Installing system unit covers270 Completing the installationFollowing screen is an example of what you should see Installation Instructions 14 30xx Memory Card Installation V5R1 820 System Units Unit CoversUnit in a rack Control panel without Electronic Keystick System unit control panelControl panel with Electronic Keystick Copyright IBM Corp IBM-CALL TrademarksHow satisfied are you that the information in this book is Readers’ Comments We’d Like to Hear from YouBusiness Reply Mail Page SENG-3002-01