IBM SENG-3002-01 Adding memory to the card assembly, Location of Card Assembly 2884 in 820 Unit

Page 11

Figure 3. Location of Card Assembly 2884 in 820 Unit

 

__ 7. Remove the 2884 card assembly

or

from the system unit by doing

the following:

 

 

__ a. Unlatch the two blue latches on the 2884 until the card assembly slightly “pops” out.

__ b. Pull on both latches at the same time to remove the card assembly from the system unit.

__ c. Turn the card assembly over and lay it on the static protective bag provided.

Adding memory to the card assembly

__ 1. Before you remove the blank filler cards and install the memory into the card assembly, read the following:

vFigure 4 on page 6 shows memory card locations on the main storage card assembly.

vFill positions C and D before installing memory cards in positions E, F, G, and H.

vInstall memory in sets of four. For example, you cannot fill only positions E and G and later fill positions F and H. You must install all four memory cards at one time.

vPairs of memory cards must be either 128MB, 256MB, or 512MB. Pairs installed in E and G must match pairs installed in F and H.

vGo to step 2 on page 6.

Installation Instructions

5

Image 11
Contents 30xx Memory Card Installation Page 30xx Memory Card Installation Second Edition May Laser Safety Information Safety and Environmental NoticesEnvironmental Design Battery Return ProgramProduct Recycling and Disposal Before you begin Installation InstructionsIdentifying the memory location Powering off the system unitYes No ↓ Go to on Remove the empty card assembly Location of Card Assembly 2884 in 820 Unit Adding memory to the card assemblyMemory Locations on Card Assembly Install Memory Cards Installing memory cards inside your system unitMemory Connectors View Memory Connectors View No Yes Installing system unit covers270 Completing the installationFollowing screen is an example of what you should see Installation Instructions 14 30xx Memory Card Installation V5R1 820 System Units Unit CoversUnit in a rack Control panel without Electronic Keystick System unit control panelControl panel with Electronic Keystick Copyright IBM Corp IBM-CALL TrademarksHow satisfied are you that the information in this book is Readers’ Comments We’d Like to Hear from YouBusiness Reply Mail Page SENG-3002-01