IBM SENG-3002-01 manual System unit control panel, Control panel without Electronic Keystick

Page 23

System unit control panel

Go to the front of your system unit. Open the control panel door.

Your control panel looks like either Figure 9 or Figure 10 on page 18. Refer to the control panel for your unit.

Figure 9. Control panel without Electronic Keystick

Power On Light

vA blinking light indicates power to the unit.

vA constant light indicates that the unit is up and working.

Power Push button

Processor Activity

System Attention

Function/Data Display

Increment/Decrement buttons

Enter Push button

Auto

Normal

Manual

.

.

.

.

.

.

.

© Copyright IBM Corp. 2000, 2001

17

Image 23

Contents 30xx Memory Card Installation Page 30xx Memory Card Installation Second Edition May Laser Safety Information Safety and Environmental NoticesEnvironmental Design Battery Return ProgramProduct Recycling and Disposal Before you begin Installation InstructionsIdentifying the memory location Powering off the system unitYes No ↓ Go to on Remove the empty card assembly Location of Card Assembly 2884 in 820 Unit Adding memory to the card assemblyMemory Locations on Card Assembly Install Memory Cards Installing memory cards inside your system unitMemory Connectors View Memory Connectors View No Yes Installing system unit covers270 Completing the installationFollowing screen is an example of what you should see Installation Instructions 14 30xx Memory Card Installation V5R1 820 System Units Unit CoversUnit in a rack Control panel without Electronic Keystick System unit control panelControl panel with Electronic Keystick Copyright IBM Corp IBM-CALL TrademarksHow satisfied are you that the information in this book is Readers’ Comments We’d Like to Hear from YouBusiness Reply Mail Page SENG-3002-01