IBM SENG-3002-01 manual Safety and Environmental Notices, Laser Safety Information

Page 5

Safety and Environmental Notices

Danger Notices

A danger notice calls attention to a situation that is potentially lethal or extremely hazardous to people.

DANGER

To prevent a possible electrical shock during an electrical storm, do not connect or disconnect cables or station protectors for communications lines, display stations, printers, or telephones. (RSFTD003)

DANGER

To prevent a possible electrical shock from touching two surfaces with different electrical grounds, use one hand, when possible, to connect or disconnect signal cables. (RSFTD004)

DANGER

An electrical outlet that is not correctly wired could place hazardous voltage on metal parts of the system or the products that attach to the system. It is the customer’s responsibility to ensure that the outlet is correctly wired and grounded to prevent an electrical shock. (RSFTD201)

DANGER

To prevent a possible electrical shock when adding or removing any devices to or from the system, ensure that the power cords for those devices are unplugged before the signal cables are connected or disconnected. If possible, disconnect all power cords from the existing system before you add or remove a device. (RSFTD203)

Caution Notices

A caution notice calls attention to a situation that is potentially hazardous to people because of some existing condition.

CAUTION:

Telecommunications Statement: This unit contains over-voltage circuits between the ac power outlet and the unit. These circuits meet the standard limits described in International Electrical Commission (IEC) 664, installation category

II.It is the customer’s responsibility to ensure that the power outlet meets the standards of IEC 664, installation category II. (RSFTC214)

Laser Safety Information

CAUTION:

This product may contain a CD-ROM which is a class 1 laser product. (RSFTC240)

© Copyright IBM Corp. 2000, 2001

iii

Image 5
Contents 30xx Memory Card Installation Page 30xx Memory Card Installation Second Edition May Laser Safety Information Safety and Environmental NoticesEnvironmental Design Battery Return ProgramProduct Recycling and Disposal Before you begin Installation InstructionsIdentifying the memory location Powering off the system unitYes No ↓ Go to on Remove the empty card assembly Location of Card Assembly 2884 in 820 Unit Adding memory to the card assemblyMemory Locations on Card Assembly Install Memory Cards Installing memory cards inside your system unitMemory Connectors View Memory Connectors View No Yes Installing system unit covers270 Completing the installationFollowing screen is an example of what you should see Installation Instructions 14 30xx Memory Card Installation V5R1 820 System Units Unit CoversUnit in a rack Control panel without Electronic Keystick System unit control panelControl panel with Electronic Keystick Copyright IBM Corp IBM-CALL TrademarksHow satisfied are you that the information in this book is Readers’ Comments We’d Like to Hear from YouBusiness Reply Mail Page SENG-3002-01