Briggs & Stratton 01933-1 Assembly, Unpacking the Generator, Install Wheel Kit, Carton Contents

BSPP Generator

ASSEMBLY	•	Engine operator’s manual
	•	(2) Locking 30A plugs
Your generator requires some assembly and is ready for	•	Battery charge cables
use after it has been properly serviced with the	•	Engine oil
recommended oil and fuel.
	•	Wheel kit
If you have any problems with the assembly of your

generator, please call the generator helpline at 1-800-743-4115.

Unpacking the Generator

1.Set the carton on a rigid flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install wheel kit.

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use. You will need the following tools to install these components:

•7/16” and 13mm wrench

•Socket wrench with a 13mm and a 7/16” socket

•Pliers

•Safety glasses

Refer to Figure 1 and install the wheel kit as follows:

Carton Contents

Check all contents. If any parts are missing or damaged, call the generator helpline at 1–800–743–4115.

•The generator

•Generator operator’s manual

1.Tip generator so that engine end is up.

2.Slide axle through both mounting brackets.

3.Place a wheel on each side with air valve facing out.

4.Place a washer on axle and then place an e-ring in axle groove.

Figure 1 — Install Wheel Kit

Handle Pin

Your unit may vary slightly from that shown here

Nylon Washer
	Nylon Washer
45 mm Cap Screw
Flat Washer	Wheel

Nut

Handle

Flat Washer

Use existing hardware Nut	Axle
	20 mm Cap Screw
to attach left side of
support leg to unit		E-Ring
Vibration Mount	Support Leg
3/4” Cap Screw	Nut

6