BSPP Generator

COLD WEATHER

OPERATION

Under certain weather conditions (temperatures below 40°F [4°C] combined with high humidity), your generator may experience icing of the carburetor and/or the crankcase breather system.To reduce this problem, you need to perform the following:

1.Make sure generator has clean, fresh fuel.

2.Open fuel valve (turn valve to open position).

3.Use SAE 5W-30 oil (see engine operator’s manual).

4.Check oil level daily or after every eight (8) hours of operation.

5.Maintain generator following “Maintenance Schedule” in engine operator’s manual.

6.Shelter unit from elements.

WARNING

Running generator gives off carbon monoxide, an odorless, colorless, poison gas.

Breathing carbon monoxide will cause nausea, fainting or death.

Operate generator ONLY outdoors.

Install a battery operated carbon monoxide alarm near the bedrooms.

Keep exhaust gas from entering a confined area through windows, doors, ventilation intakes or other openings.

DO NOT operate generator inside any building or enclosure (even if doors or windows are open), including the generator compartment of a recreational vehicle (RV).

6.Start generator as described in the section “Starting the Engine”, then place carton over generator. Keep at least 5 ft. (152 cm) clearance on all sides of generator including overhead with shelter in place.

Creating a Temporary Cold Weather Shelter

1.In an emergency, use the original shipping carton.

2.Cut off top carton flaps and one long side of carton to expose muffler side of unit. If required, tape up other sides of carton to fit over generator as shown in Figure 7.

NOTE: If required, remove wheel kit to fit carton over generator as shown in Figure 7.

Figure 7 — Permanent Cold Weather Shelter

Wind

3.Cut appropriate slots to access receptacles of unit.

4.Face exposed end away from wind and elements.

5.Locate generator as described in the section “Generator Location”. Keep exhaust gas from entering a confined area through windows, doors, ventilation intakes or other openings.

WARNING

Running engines produce heat.Temperature of muffler and nearby areas can reach or exceed 150°F (65°C).

Severe burns can occur on contact.

Exhaust heat/gases can ignite combustibles, structures or damage fuel tank causing a fire.

DO NOT touch hot surfaces and avoid hot exhaust gases.

Allow equipment to cool before touching.

Keep at least 5 ft. (152 cm) clearance on all sides of generator including overhead.

Remove shelter when temperatures are above 40°F [4°C].

7.Remove shelter when temperatures are above 40°F [4°C].

8.Turn engine OFF and let cool two (2) minutes before refueling. Let any spilled fuel evaporate before starting engine.

Creating a Permanent Cold Weather Shelter

1.Build a structure that will enclose three sides and the top of the generator, making sure muffler side of generator is exposed.

NOTE: Structure should hold enough heat created by the generator to prevent icing problem.

2.DO NOT enclose generator any more than shown in Figure 7.

NOTE: If a wheel kit is installed on the generator, enlarge shelter accordingly.

3.Follow steps 3 through 8 as described previously in “Creating a Temporary Cold Weather Shelter”.

11

Page 11
Image 11
Briggs & Stratton 01933-1 manuel dutilisation Cold Weather Operation, Creating a Temporary Cold Weather Shelter

01933-1 specifications

The Briggs & Stratton 01933-1 is a powerful and reliable portable generator designed to meet the diverse needs of users, whether for home use, construction sites, or recreational activities. This versatile generator stands out due to its robust performance, innovative technologies, and user-friendly features.

One of the primary features of the Briggs & Stratton 01933-1 is its impressive power output. With a peak wattage of 7,500 watts and a running wattage of 6,000 watts, this generator provides ample electricity to run essential appliances, power tools, and other equipment during outages or outdoor adventures. The generator's ample starting power ensures that it can easily handle high-demand devices such as refrigerators, air conditioners, and other household electronics.

Equipped with a powerful Briggs & Stratton engine, this generator features a reliable 306cc overhead valve design that enhances fuel efficiency and performance. The engine's low-oil shutdown feature adds an additional layer of protection, automatically turning off the generator when oil levels drop too low, preventing potential damage and extending the lifespan of the unit.

The Briggs & Stratton 01933-1 incorporates advanced technology with its Easy Start System, which allows for effortless starting in various conditions. The generator is designed for optimal fuel consumption, allowing users to maximize run time on a single tank of gas, which is particularly beneficial during extended power outages or remote work sites.

Another noteworthy characteristic is the generator's durable construction. Built with a heavy-duty frame and oversized wheels, the 01933-1 can handle rough terrains and is easy to transport. The generator's compact design does not compromise stability, providing a secure operating platform without excessive noise levels, thanks to its sound-dampening features.

Safety is prioritized in the Briggs & Stratton 01933-1, as it includes several safety features such as circuit breakers and grounded outlets that help protect against overloads and ensure safe operation. Additionally, it has multiple outlets, including a 120/240V outlet, making it versatile enough for a wide range of applications.

In conclusion, the Briggs & Stratton 01933-1 is an excellent choice for anyone in need of a dependable and efficient portable generator. With its powerful performance, advanced engine technology, and robust safety features, it is well-equipped to provide reliable power wherever and whenever required. Whether you are preparing for emergencies, working on a job site, or enjoying outdoor activities, the Briggs & Stratton 01933-1 is a generator that can truly meet your power needs.