Maintenance
Replacing the fuse
A power surge or spike can blow the power supply fuse and cause the LitePro to stop working. If this happens, you’ll need to replace the fuse.
Use only the specified power supply fuse. Using a different fuse may cause serious damage to the LitePro.
The correct fuse for your LitePro is a 6.3A. 250V. T. 5x20 mm fuse.
Follow these steps to replace the fuse.
1.Make sure that the condition that caused the fuse to blow no longer exists.
2.Turn off and unplug the projector.
3.Remove the fuse holder, located just below the power cord con- nector, from the projector.
• Pull out the fuse holder with a screwdriver as shown.
LitePro 580 User’s Guide | 53 |