Troubleshooting
Problem: Fuzzy vertical bars in image
•Adjust Tracking.
•If your computer is a Macintosh, select the “Mac LC” box in the LitePro’s Computer menu (see page 26).
•Make sure your cables are connected correctly and adjust signal synchronization from the remote.
Problem: Image and menus are reversed left to right
•Rear projection is turned on. Select “Rear Proj” on the Display menu to turn it off.
Problem: LitePro displays vertical lines, “bleeding” or spots
• Adjust Brightness.
Problem: Image is “noisy” or streaked with horizontal lines
• Adjust Sync.
Problem: Dim image
•Adjust Brightness.
•Adjust Contrast.
•Replace lamp if it has been used for over 500 hours.
Problem: Remote control doesn’t work
•Check the batteries. They may need to be replaced or they may be loaded incorrectly.
•Make sure nothing is blocking the remote control receiver on the projector.
•Make sure you are not too far from the projector when using the remote. It has a limited range.
58 | LitePro 580 User’s Guide |