IBM 09N4076 manual Settings, Configuration, For

Appendix

C.

Customizing

device

driver

configuration

settings

Attention:

After

you

install

theIBM Option Diskette

,

you

can

use

a

DOS

session

in

Windows

3.x,

DOS,

OS/2,

Windows

98,

and

Windows

95

to

access

the

drive

as

a

CD-ROM

drive.

This

section

contains

optional

configuration

information

for

the

IBM Option Diskette

device

drivers

for

Windows

3.x,

DOS, OS/2

and

Windows

98

and

95.

Use

the

online

help

during

the

installation

and

refer

to

the

READ.ME

file

on

the IBM Option Diskette

for

additional

information.

Requirements

vary,

and

you

might

need

to

customize

the

configuration

that

the

CDSETUP

program

installed

on

your

computer.

This

section

provides

information

and

describes

parameters

that

you

might

need

to

change

or

add

for

your

installation.

Changing

device

driver

parameters

for

DOS

and

Windows

3.x

Most computers will function adequately with the

default

settings

for

the

IBMIDECD.SYS

device

driver

file. However,

there

are

some

parameters

that

can

be

changed

if

necessary.

This

section

explains

the

function

of

each

parameter.

Use a

text

editor

to modify the appropriate line in

your

CONFIG.SYS

file.

For

the

IBMIDECD.SYS

device

driver

file,

the

line

in

CONFIG.SYS

is

in

the

following

format:

DEVICE=[drive:][path]IBMIDECD.SYS /D:device name

[/P:xxx,yy] [/A:n] [/U:n]

[/L:xx] [/T:n] [/I:n]

(Do

not

truncate

the

actual

device

driver

entry.

Place

the

complete

DEVICE=

on

one

line

in

the

CONFIG.SYS

file.)

[drive:][path]IBMIDECD.SYS

The

above

parameter

specifies

the

location

(drive

and

directory)

and

name

of

the

device

driver

file.

Use

the

following

options

to

configure

the

device

driver.

/D:device

name

This

parameter

specifies

the

device

name

of

the

CD-ROM

drive.

This

name

must be identical to the device

name

specified

in

the

MSCDEX.EXE

parameters,

as

shown:

DEVICE=C:\IBMIDECD.SYS /D:IBMCD1ðð

/P:xxx,yy

This

parameter

specifies

the

address

and

interrupt

level

of

the

port

to

which

the

IDE

CD-ROM

drive

is

connected.

Part 2: Appendixes 2-13