IBM L190P manual Auto Image Setup Analog Only

Auto Image Setup (Analog Only)

Auto Image Setup

The Setup Utility included on the setup diskette is for displaying dot patterns. They do not replace or modify the display driver.

The Auto Image Setup instructions require the monitor to be warmed up for 15 minutes. This is not required for normal operation.

When you first use your monitor you must perform Auto Image Setup. This procedure sets up your monitor to process the video signals from your computer without image discoloration or smearing. After you perform Auto Image Setup, the settings are stored and used each time you turn on the monitor.

To optimise the displayed image a set-up utility is provided on the CD. Operation of the utility is dependent on the operating system on your computer. For correct operation locate the operating system on your computer from the table below and follow the appropriate instructions. You can choose to run AUTO IMAGE SETUP for each operating system that you use. This means that if you sometimes use your monitor while running any version of Windows and sometimes also use it from within DOS (not a DOS window), you must run AUTO IMAGE SETUP for both Windows and DOS. You can run versions of AUTO IMAGE SETUP in any order.

Operating System	Corresponding Auto Image Setup procedure
DOS	Auto Image Setup for DOS on page 15
Windows 3.1, Windows 95,	Auto Image Setup for Windows 3.1, Windows
Windows 98, Windows 2000,
Microsoft Windows NT®,	95, Windows 98, Windows NT, Windows 2000,
	Windows Me or Windows XP
Windows Me or Windows XP

The AUTO IMAGE SETUP

process only applies to the current screen mode. When a new mode is selected, repeat this section to reset the monitor

Before you begin AUTO IMAGE SETUP for your computer:

1.Make sure the computer’s video mode is set in the range of the supported screen resolution shown in the Table on page 26.

You should perform AUTO IMAGE SETUP for each screen mode you use.

14