IBM L190P manual Auto Image Setup for DOS

Page 17

Auto Image Setup for DOS

ENGLISH

If the monitor is in standby mode (STANDBY ON), it

may automatically turn off while you are waiting for it to warm up. If this happens, switch off the monitor and switch it on again after a few seconds.

If you are using PC-DOS/V, change to U.S. mode by

typing ‘CHEV US’ and pressing ENTER at the command prompt.

The size and diversity of the dot pattern varies with the

screen resolution.

To optimize the displayed image automatically in DOS, do the following:

1.Turn on the monitor first; then turn on the computer.

If the message CHECK SIGNAL CABLE is displayed, or if nothing is displayed, check:

that the video interface cable is connected properly.

the correct video adapter card is installed.

the correct supported display mode is selected for your computer.

2.Wait approximately 15 minutes, until the monitor warms up.

3.Insert the User’s Guide and Installation Files CD into the computer CD- ROM drive.

4.Display the command prompt screen of the DOS full-screen display.

5.Type d:\ (change the drive letter to match your CD-ROM drive if it is not drive D).

6.Type TESTPATD and press ENTER.

7.Select from the screen the number for the color or text mode you want to set up.

8.Select from the screen the number for the video mode you want to set up. You can repeat this process for as many of the color and video modes as you need.

9.When the dot pattern appears, press the OSD Enter button at the bottom of the monitor to display the initial OSD menu.

10.Use an Arrow button ( or ) to select the Image Setup icon

then press the OSD Enter button to access the function.

11.Using an Arrow button ( or ), select AUTOMATIC and press the OSD Enter button . This activates the AUTO IMAGE SETUP procedure, which will optimize the display settings with the provided dot-patterns. The screen will flash off several times and you might notice small changes to the test pattern.

12. When finished, the OSD main menu returns. Press the Exit button to exit from the OSD.

13.Press the ESCAPE key to exit the test pattern program.

14.Type Exit at the command prompt to return to Windows.

If you use other operating systems, perform the appropriate Auto Image Setup for those systems using instructions given in “Auto Image Setup for

Windows 3.1, Windows95, Windows 98, Windows NT, Windows Me or Windows XP on page 16”

FRANÇAIS

COMPL & WARR JAPANESE ITALIANO ESPAÑOL

15

Image 17
Contents IBM ThinkVision L190p Monitor L190pFirst Edition September/2003 Contents Page Handling Instructions Setting up the monitorProduct Description Orientation Workplace PreparationHeight Working Practices Adjusting the Monitor PositionViewing Angle BackEyesight Screen settingsCaring for your Monitor English Connecting your Monitor for AnalogDVI Connecting your Monitor for DigitalSwitching on your Monitor Installing the Windows Me device driver Device Driver InstallationInstalling the Windows XP device driver Installing the Windows 98 device driver Installing the Windows 2000 device driverInstalling the Windows 95 device driver Select Device window, click Have Disk Auto Image Setup Auto Image Setup Analog OnlyAuto Image Setup for DOS \TESTPAT Operating system installation stepsOperating system, go to .Auto Image Setup for DOS on Manual Image Setup User controls Adjusting Your LCD MonitorUser control features OSD Lock / Unlock OperationInitial appearance of OSD OSD functions On-screen display OSD controlsOSD Icon on Submenu Description Controls Options Adjusts menu location on the screen Display modes Further InformationFactory Set Display Modes For image problems, youProduct Disposal Power ManagementFor Analog TroubleshootingUser Problem Possible Suggested Action Reference Cause Further Help DVI SpecificationsFrançais English Model Type Service InformationThis section contains information on notices and trademarks Trademarks