Manual Image Setup
If the monitor is in standby mode (STANDBY ON), it
might automatically turn off while you are waiting for it to warm up.
Normally, you can complete the setup procedure using AUTO IMAGE SETUP; however, if your screen image is still distorted after you perform AUTO IMAGE SETUP or the Installation CD does not run on your system, perform MANUAL
IMAGE SETUP.
1.Have your monitor turned on for about 15 minutes, until the monitor warms up.
2.Display the image you most frequently use on the screen.
3.Press the OSD Enter button 
at the bottom of the monitor to display the initial OSD menu.
4.Use an Arrow button ( 
or 
) to select the Image Setup icon 
and press the OSD Enter button 
to access the function.
5.Using an Arrow button ( 
or 
), select MANUAL, press 
and then
press 
again to access the Clock function (see page 22) .
6.Use the Arrow buttons ( 
or 
) to manually adjust the image (as much as possible).
7. Next press the | button to select Phase. |
8.Use the Arrow buttons ( 
or 
), again to tune the image to your
liking. To save, press the 
button two times.
9.When finished, press the Exit button 
to exit from the OSD.
You have completed the monitor manual image setup procedure.
18