4.Connect the DVI connector at the other end of the signal cable to the DVI port located on the back of the graphics adapter. See picture below.
graphics adapter |
DVI
Signal Cable
5.Connect the power cord to the power port on the back of your monitor if the power cord supplied is not attached to the monitor. Then insert the plug into a properly grounded electrical outlet.
6.Use the cable holder (a) to neatly organize the video and power cables.
7.Switch on the power source and your computer. To turn on the monitor, push and release the power switch 
. To switch it off, push and release the power switch again.
Switching on your Monitor
1.Switch on the power source and your computer.
2.Switch on your monitor by pushing and releasing the power switch marked 
.
(To switch off your monitor, push and release the power switch again).
3.To update or install device drivers, follow the instructions in the Device Driver Installation section found on page 10.
4.To optimize the displayed image, run Auto Image Setup by following the instructions in the Auto Image Setup section found on page14.
FRANÇAIS ENGLISH
COMPL & WARR JAPANESE ITALIANO ESPAÑOL
9