IBM L190P manual Power Management, Product Disposal

Page 29

Power Management

ENGLISH

If your computer has previously been used with a CRT monitor and is

currently configured to a display mode outside the range that the Flat Panel monitor can display, you may need to re-attach the CRT monitor temporarily until you have re-configured the computer, preferably to 1280 x 1024 at 60Hz.

To benefit from power management, the monitor must be used in conjunction with a computer that implements the Video Electronics Standards Association (VESA) Display Power Management Signaling (DPMS) Standard.

The power management feature is invoked when the computer recognizes that you have not used your mouse or keyboard for a user-definable period. There are several states as described in the table below.

As an ENERGY STAR® Partner, IBM has determined that this product meets the ENERGY STAR® guidelines for energy efficiency.

For optimal performance, switch off your monitor at the end of each working day, or whenever you expect to leave it unused for long periods during the day.

State

Power

Screen

Restoring

Compliance

Indicator

Operation

 

 

 

 

 

 

 

 

 

 

 

 

 

On

Blinking green

Normal

 

 

 

 

 

 

 

Active off

Blinking green

Blank

Press a key or

ENERGY STAR®

move the mouse. *

 

 

 

 

 

 

 

 

 

* There may be a slight delay before the picture reappears.

FRANÇAIS

ITALIANO ESPAÑOL

Product Disposal

The fluorescent lamp in the liquid crystal display contains a small amount of mercury. Dispose of it as required by local ordinances and regulations.

COMPL & WARR JAPANESE

27

Image 29
Contents IBM ThinkVision L190p Monitor L190pFirst Edition September/2003 Contents Page Handling Instructions Setting up the monitorProduct Description Orientation Workplace PreparationHeight Working Practices Adjusting the Monitor PositionViewing Angle BackEyesight Screen settingsCaring for your Monitor English Connecting your Monitor for AnalogDVI Connecting your Monitor for DigitalSwitching on your Monitor Installing the Windows Me device driver Device Driver InstallationInstalling the Windows XP device driver Installing the Windows 98 device driver Installing the Windows 2000 device driverInstalling the Windows 95 device driver Select Device window, click Have Disk Auto Image Setup Auto Image Setup Analog OnlyAuto Image Setup for DOS \TESTPAT Operating system installation stepsOperating system, go to .Auto Image Setup for DOS on Manual Image Setup User controls Adjusting Your LCD MonitorUser control features OSD Lock / Unlock OperationInitial appearance of OSD OSD functions On-screen display OSD controlsOSD Icon on Submenu Description Controls Options Adjusts menu location on the screen Display modes Further InformationFactory Set Display Modes For image problems, youProduct Disposal Power ManagementFor Analog TroubleshootingUser Problem Possible Suggested Action Reference Cause Further Help DVI SpecificationsFrançais English Model Type Service InformationThis section contains information on notices and trademarks Trademarks