IBM E74M manual Compliances, Federal Communications CommissionFCC Statement

Page 33

Compliances

Federal Communications Commission(FCC) Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult an IBM authorized dealer or service representative for help.

Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Proper cables and connectors are available from IBM authorized dealers. IBM is not responsible for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Industry Canada Compliance Statement

This Class B digital apparatus meets the requirements of the Canadian Interference-Causing Equipment Regulations.

Cet appareil numerique de la Classe B respecte toutes les exigences du Reglement sur le materiel brouilleur du Canada.

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Edition TrademarksEnergy Star is a U.S. registered mark Product package should include the following items Packing ListTable of Contents Introduction FeaturesPrecautions Rest Screen settingsBack HandsPower cord Power SourceConnecting the Monitor Location and Function of Controls Control Panel Function Front Panel ControlsControl Function Left Side Jacks Audio FeaturesRear Panel Jacks Microphone OperationOn Screen Display OSD Control Adjustment On Screen DisplayOSD Selection and Adjustment OSD AdjustA10 A11 DescriptionColor Select A12A13 Mode InformationA14 Sound Selection and AdjustmentVideo Memory Modes Display Modes ResolutionUser Modes Recalling Display ModesPower Consumption Energy Saving DesignA16 Page Troubleshooting Further help Call IBM Helpcenter USA call Canada callA19 A20 ServiceSync Signal Types SpecificationsSignal Connector Pin Assignment SignalD-Sub Separate SyncDimensions with tilt/swivel stand Power inputWeight Picture tubeA23 Statement of WarrantyA24 Warranty ServiceLimitation of Liability A25EUROPE, Middle EAST, Africa Emea A26A27 Following is added to this Section A28A29 Compliances Federal Communications CommissionFCC StatementIndustry Canada Compliance Statement Power Cord European Union EU Statement HinweiseHinweis fü r die Europäische Union EU Déclaration de l’Union européenne UEDichiarazione della Comunità Europea EU Declaració n de la EU Unió n Europea Service Information
Top Page Image Contents