Appendix C Configuring the Switch with the
Entering the Initial Configuration Information
Step 3 Configure the baud rate and character format of the PC or terminal to match these console port default characteristics:
•9600 baud
•8 data bits
•1 stop bit
•No parity
•None (flow control)
Step 4 Press the Enter key. This prompt appears:
Switch>
Entering the Initial Configuration Information
To set up the switch, you need to complete the setup program, which runs automatically after the switch is powered up. You must assign an IP address and other configuration information necessary for the switch to communicate with the local routers and the Internet. This information is also required if you plan to use the Network Assistant to configure and manage the switch.
IP Settings
You will need this information from your network administrator before you complete the setup program:
•Switch IP address
•Subnet mask (IP netmask)
•Default gateway (router)
•Enable secret password
•Enable password
•Telnet password
Catalyst 2940 Switch Hardware Installation Guide
| ||
|