
Install the SFP Modules and Connect to the Ports
Follow these steps:
Step 1 Grasp the module on the sides, and insert it into the switch slot until you feel the connector snap into place.
Step 2 Insert an appropriate cable into the module port. Insert the other cable end into the other device.
Catalyst |
|
|
| |
W | 3750G | SERIES | ||
ireless |
| |||
| LAN | |||
|
|
| Controller |
13 | 14 | 16 |
|
|
|
|
13X | 15 |
|
|
|
| |
|
| 17 | 18 | 20 |
|
|
|
|
| 19 | 22 |
| |
|
|
|
| 21 | 24 | |
|
|
|
|
| 23 | |
|
|
|
|
|
| 23X |
14X |
|
|
|
|
|
|
25 26
SFP module
Catalyst |
|
|
| |
W | 3750G | SERIES | ||
ireless |
| |||
| LAN | |||
|
|
| Controller |
13 | 14 | 16 |
|
|
|
|
13X | 15 |
|
|
|
| |
| 17 | 18 |
|
|
| |
|
|
| 19 | 20 | 22 |
|
|
|
|
| 21 | 24 | |
|
|
|
|
| 23 |
23X
14X
26
SFP module port
For a list of supported modules, see the release notes on Cisco.com. For detailed instructions on installing, removing, and connecting to SFP modules, see the documentation that came with the SFP module.
Caution Removing and inserting an SFP module can shorten its useful life. Do not remove and insert SFP modules more often than is absolutely necessary.
Verify Port Connectivity
After you connect to the switch port, the port LED turns amber while the switch establishes a link. This process takes about 30 seconds. Then the LED turns green when the switch and the target device have an established link. If the LED is off, the target device might not be turned on, there might be a cable problem, or there might be a problem with the adapter installed in the target device. See the “In Case of Difficulty” section on page 34 for information about online assistance.
33