58721

Replacing the Cisco uBR-MC28C Line Card in the Cisco uBR10-LCP2 Adapter Card

Figure 12 Removing the Cisco uBR-MC28C Cable Interface Line Card from the Cisco uBR10-LCP2 Adapter Card

ENABLED

US0

US1

US2

US3

US4

US5

US6

US7

uBR- MC28C DS0

DS1

Step 8 Place the removed Cisco uBR-MC28C cable interface line card aside on an anti-static surface.

Installing the Cisco uBR-MC28C Cable Interface Line Card in the Cisco uBR10-LCP2 Adapter Card

Tip Make sure that you are using the ESD-preventive wrist strap.

Step 1 Align the cable interface line card with the guide rails on the Cisco uBR10-LCP2 adapter card. Ensure that the bottom of the cable interface line card is flush with the bottom of the LCP2 adapter card.

Step 2 Slide the new cable interface line card into the adapter card slowly, making sure that the card is sliding under the spring guides and into the guides (see Figure 3 on page 5).

Step 3 Verify that the power connectors are aligned with those on the adapter card.

Step 4 Make sure that the screws on the adapter card brackets slide cleanly into the holes in the L-brackets.

Step 5 Continue pushing on the front of the card until the connectors on the card are firmly seated in the connectors on the adapter card. The ejector levers on each side of the card snap into place when the card is fully inserted.

Cisco uBR10-LCP2-MC28C Cable Interface Line Card for the Cisco uBR10012 Router

	OL-4653-01	21