Cisco Systems uBR10-LCP2-MC28C manual Connecting the Cables

Page 22

Replacing the Cisco uBR-MC28C Line Card in the Cisco uBR10-LCP2 Adapter Card

Note These brackets help align the adapter card and Cisco uBR-MC28C cable interface line card connectors and hold the Cisco uBR-MC28C cable interface line card in place.

Step 6 Tighten the captive screws on the Cisco uBR-MC28C cable interface line card to secure it to the Cisco uBR10-LCP2 adapter card.

Step 7 Replace the retaining washers and retaining nuts on the L-brackets (see Figure 11 on page 20). Make sure they are finger-tight and then turn them a half-turn with a wrench to secure them and the Cisco uBR-MC28C cable interface line card.

Replacing the Cisco uBR10-LCP2-MC28C Cable Interface Line Card in the Chassis

Tip Make sure that you are using the ESD-preventive wrist strap.

Step 1 Grasp the faceplate of the new cable interface line card with one hand and place your other hand under the card carrier (to support the weight of the card) and position the card in front of the card cage slot.

Step 2 Carefully align the upper and lower edges of the cable interface line card with the upper and lower guides in the chassis, and slide the card into the slot until you can feel it begin to seat in the backplane connectors (Figure 8 on page 16).

Step 3 Simultaneously pivot both ejector levers toward each other (until they are parallel to the faceplate) to firmly seat the card in the backplane (Figure 9 on page 17).

Step 4 Secure the cable interface line card in the chassis by tightening the top and bottom captive screws (see Figure 5 on page 13).

Caution To ensure that there is adequate space for additional cable interface line cards, always tighten the captive screws on each newly installed card before you insert any additional cards. These screws prevent accidental removal and provide proper grounding for electromagnetic interference (EMI) shielding.

Connecting the Cables

When fully inserted, the cable interface line card cycles through its power-on self-test. The Power LED is on (green) and the Status LED turns yellow. If the card is operating correctly, the Status LED then turns green. If these LED do not operate as described, refer to the Cisco uBR10012 Universal Broadband Router Hardware Installation Guide at the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/cable/ubr10k/ubr10012/hig/index.htm

Cisco uBR10-LCP2-MC28C Cable Interface Line Card for the Cisco uBR10012 Router

22

OL-4653-01

 

 

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Audience PurposeScope Contents Cisco uBR10-LCP2-MC28C OverviewQPSK, 16 QAM Cisco uBR10012 Router Chassis Slot Numbering Physical Description MC28CLED Technical Specifications Description SpecificationsElectrical Equipment Guidelines Safety Information and WarningsPreventing Electrostatic Discharge Damage Statement 1071-Warning Definition Bewaar Deze InstructiesBewahren SIE Diese Hinweise GUT AUF Spara Dessa Anvisningar Unpacking and Preparing Tools and Parts RequiredRemoving a Cable Interface Line Card from the Chassis Captive screws Opening the Ejector Levers Make sure that you are using the ESD-preventive wrist strap Inserting the Cable Interface Line Card Closing the Ejector Levers Connecting the Cables Removing the Nuts and Washers 62668 58721 Connecting the Cables Page Obtaining Documentation Related DocumentationWorld Wide Web Ordering Documentation Obtaining Technical AssistanceDocumentation CD-ROM Documentation FeedbackCisco.com Technical Assistance CenterCisco TAC Escalation Center Obtaining Technical Assistance
Top Page Image Contents