Chapter 2 Installing the Cisco Unified Videoconferencing 3545 MCU
Initial 3545 EMP Configuration
Pointing the EMP to the Controlling MCU
You can use the serial port to point the EMP to the IP address of the controlling MCU.
Procedure
Step 1 At the prompt, enter M to change the MCU IP address and press Enter.
The MCU IP address screen displays as follows:
Enter MCU ip address
Without leading zeros <current IP address>:
Step 2 Enter the IP address of the MCU and press any key to return to the EMP Main menu.
Changing Advanced Configuration Settings
You can use the serial port to change the following advanced configuration settings:
•Web server port (for future use)
•Restore factory configuration (for future use)
•LAN port settings
•Disable DSP reset
Procedure
Step 1 At the prompt, enter A to access the Advanced Configuration menu.
The Advanced Configuration menu displays as follows:
Advanced configuration menu
Q: Quit
1:Configure web server port
2:Restore factory configuration
3:Change Lan port Settings
4:Disable DSP reset
Select:
Step 2 At the prompt, enter 1 to configure the web server port.
The current web port server setting displays.
Step 3 At the prompt, enter 2 to restore the factory configuration settings.
You are asked to confirm your choice as follows:
Select: 2
Are you sure you want to restore factory configuration? [y, n]:
Step 4 Enter y or n.
Step 5 At the prompt, enter 3 to change Ethernet speed and duplex parameters.
The network interface card settings screen appears as follows:
Choose : 1 - 10Mbps Half Duplex
:2 - 100Mbps Half Duplex
:3 - 10Mbps Full Duplex
:4 - 100Mbps Full Duplex
| Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 MCU Release 5.1 |