Cisco Systems manual Verifying the Package Contents of the 3545 MCU

Page 4

Chapter 2 Installing the Cisco Unified Videoconferencing 3545 MCU

Verifying the Package Contents of the 3545 MCU

For a Skinny Client Control Protocol (SCCP) environment, the IP address of the Trivial File Transfer Protocol (TFTP) server or Cisco Unified CallManager from which you want the MCU and EMP to get configuration information

Available IP network ports on the switch for the MCU and EMP

A grounded AC power outlet

A 10BaseT or 100BaseT LAN cable

Ambient room temperature range of 32o to 122oF (0o to 50oC)

Non-condensing relative humidity range of 5% to 85%

Verifying the Package Contents of the 3545 MCU

Inspect the contents of the box for shipping damage. Report any damage or missing items to your Cisco representative. Table 2-2lists the package contents for the MCU and EMP.

Table 2-2 Package Contents with Cisco Unified Videoconferencing 3545 MCU and Cisco Unified Videoconferencing 3545 EMP

Product

Contents

 

 

 

Cisco Unified

Cisco Unified Videoconferencing 3545 MCU module

Videoconferencing

Cisco Unified Videoconferencing 3545 EMP module

3545 chassis with

Guide to Cisco Conferencing Documentation

MCU and EMP

 

Regulatory Compliance and Safety Information for Cisco Unified

 

 

Videoconferencing 3500 Products

 

Cisco Unified Videoconferencing Software CD-ROM

 

Cisco Information Package

 

 

 

Mounting the Cisco Unified Videoconferencing 3545 Chassis in a 19-inch Rack

You can optionally mount the Cisco Unified Videoconferencing 3545 chassis in a standard 19-inch rack. Two mounting brackets and a set of screws are included in the Cisco Unified

Videoconferencing 3545 chassis shipping box.

Procedure

Step 1 Disconnect all cables including the power cables.

Step 2 Place the Cisco Unified Videoconferencing 3545 chassis right-side up on a hard flat surface, with the front panel facing you.

Step 3 Position a mounting bracket over the mounting holes on each side of the Cisco Unified Videoconferencing 3545 chassis, as shown in Figure 2-3.

Step 4 Pass the screws through the brackets and tighten them into the screw holes on each side of the Cisco Unified Videoconferencing 3545 chassis using a suitable screwdriver.

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 MCU Release 5.1

2-4

OL-11899-01

 

 

Image 4
Contents Installing the Cisco Unified Videoconferencing 3545 MCU Component Description Preparing to Install the 3545 MCU ACT LEDVerifying the Package Contents of the 3545 MCU Installing the 3545 MCU and EMP 157274 Removing the 3545 MCU and EMP Connecting to a PC Initial 3545 MCU ConfigurationSetting the IP Address Requirements Setting Ethernet Speed and Duplex Parameters Setting a Tftp Server Changing the Global User Name and Password Initial 3545 EMP Configuration Upgrading Cisco Unified Videoconferencing 3545 MCU SoftwareSetting the IP Address Changing the Configuration Software Password Changing the Security LevelChanging Advanced Configuration Settings Pointing the EMP to the Controlling MCUSaving Network Configuration Settings Connecting the EMP to the LANAccessing the 3545 MCU Administrator Interface Using the 3545 MCU Setup Wizard Registering the Online Help for the 3545 MCU Netscape Navigator Users