Cisco Systems 3515 MCU24, 3515 MCU12 manual Product Contents, Before You Begin

Page 15

Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3515 MCU

Mounting the Cisco Unified Videoconferencing 3515 MCU Unit in a 19-inch Rack

Table 2-2 Package Contents with Cisco Unified Videoconferencing 3515 MCU12 or

Cisco Unified Videoconferencing 3515 MCU24 Unit

Product

Contents

 

 

 

Cisco Unified

Cisco Unified Videoconferencing 3515 MCU12 or Cisco Unified

Videoconferencing 3515

 

Videoconferencing 3515 MCU24 unit

MCU unit

Power cable (depending on customer location)

 

 

Terminal cable

 

2 LAN cables (one for the MCU, one for the video processing

 

 

module)

 

Rack mounting kit (two brackets and six screws)

 

Four rubber feet

 

Guide to Cisco Conferencing Documentation

 

Regulatory Compliance and Safety Information for Cisco Unified

 

 

Videoconferencing 3500 Products

 

Cisco Unified Videoconferencing Software CD-ROM

 

Cisco Information Package

 

 

 

Mounting the Cisco Unified Videoconferencing 3515 MCU Unit in a 19-inch Rack

You can optionally mount the Cisco Unified Videoconferencing 3515 MCU unit in a standard 19-inch rack. Two mounting brackets and a set of screws are included in the Cisco Unified Videoconferencing 3515 MCU unit shipping box.

Before You Begin

The requirements are as follows:

Proper clearance at the sides of the unit to allow adequate ventilation, and at least 20 cm clearance at the back of the unit to allow access to cable connections

Available IP network ports on the switch for the Cisco Unified Videoconferencing 3515 MCU unit

A grounded AC power outlet

A 10BaseT or 100BaseT LAN cable

Ambient room temperature range of 32o to 104oF (0o to 40oC)

Non-condensing relative humidity range of 5% to 90%

Procedure

Step 1 Disconnect all cables including the power cables.

Step 2 Place the Cisco Unified Videoconferencing 3515 MCU unit right-side up on a hard flat surface with the front panel facing you.

Step 3 Position a mounting bracket over the mounting holes on each side of the Cisco Unified Videoconferencing 3515 MCU unit, as shown in Figure 2-2.

Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU Release 5.6

 

OL-17012-01

2-3

 

 

 

Image 15
Contents Text Part Number OL-17012-01 Americas HeadquartersPage N T E N T S Safety Administrators FunctionalityAbout theCisco Unified Videoconferencing 3515 MCU Conference Users Main FeaturesFeature Description Moderators and OperatorsSccp Port Capacities Cisco Unified Videoconferencing 3515 MCU24 Port Capacity Cisco Unified Videoconferencing 3515 MCU12 Port CapacityAbout Cisco Unified Videoconferencing 3515 MCU Architecture Cascaded Conferences Centralized TopologyCascaded Conference Physical Description Setting Up Your Cisco Unified Videoconferencing 3515 MCUVerifying the Package Contents Before You Begin Product ContentsFitting a Bracket for Rack Mounting About the Initial Configuration and Boot PhasesSetting the IP Address Connecting to a PCProcedure Setting Ethernet Speed and Duplex Parameters About the Initial Video Processing Module Configuration Accessing the Video Processing Module Main Menu Changing the Security Level Changing the Configuration Software PasswordAdvanced Configuration menu appears as follows Changing Advanced Configuration SettingsConnecting the EMP to the LAN Saving Network Configuration SettingsPerforming Software Upgrades Snmp ManagementLocal Port Monitoring Connections Before You Begin Registering the Online Help for the 3515 MCU OL-17012-01 Using the Cisco Software Upgrade Utility About the Cisco Software Upgrade UtilityLaunching the Cisco Software Upgrade Utility Upgrading Software Click Customize Snmp SettingsCable Connections and Pin-outs RS-232 9-Pin Serial PortPin Function RJ-45 8-Pin IP Network Port TXD+RXD+ Technical Specifications Failsafe Safety Electrical SafetyGrounding ESD Procedures BatteriesHigh Voltage Safety Compliance Compliance and CertificationsCISPR24 CE CTR3, CE CTR4 TelecomFCC Part 15 Notice Acta Part 68 NoticeIndustry Canada Environmental ComplianceOL-17012-01 Numerics IN-2 Snmp IN-4