Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3515 MCU
How to Perform the Cisco Unified Videoconferencing 3515 MCU Unit Initial Configuration
Step 11 At the network configuration Main menu, enter Q to save your changes and allow the device to complete the boot process.
Caution Configuration of any of the parameters other than N: Configure default network port values may alter the function of the device and should not be performed by an unauthorized person.
Setting Ethernet Speed and Duplex Parameters
Use the serial port to set the Ethernet speed and duplex parameters that you want the Cisco Unified Videoconferencing 3515 MCU to use.
Procedure
Step 1 Access the Cisco Unified Videoconferencing 3515 MCU through the serial port and start a terminal emulator session.
Note If the Cisco Unified Videoconferencing 3515 MCU is already running, you need to reboot or restart the device.
Step 2 When the message “Press any key to start configuration” appears on the screen, press any key within six seconds.
The network configuration Main menu appears.
Step 3 At the prompt, enter A to display the Advanced Configuration menu and press Enter.
The Advanced Configuration menu appears.
Step 4 At the prompt, enter 3 to select “Change LAN port Settings” and press Enter.
Step 5 At the prompt, enter the number or letter for one of the following:
•1 - 10Mbps Half Duplex
•2 - 100Mbps half Duplex
•3 - 10Mbps Full Duplex
•4 - 100Mbps Full Duplex
•5 - Auto
•Q - Quit
Note We recommend that you select “5 - Auto’ here and also set the Port settings option to “Auto” in the Cisco Unified Videoconferencing 3515 MCU web user interface at MCU > Device > Addressing.
Step 6 Press Enter.
The network configuration Main menu appears.
Step 7 At the Network Configuration menu, do one of the following:
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU Release 5.6
|
| ||
|
|