Saving Network Configuration Settings

Chapter 2 Setting Up Your Cisco Unified Videoconferencing 3515 MCU

How to Perform the Video Processing Module Initial Configuration

The network interface card settings screen appears as follows:

Choose : 1 - 10Mbps Half Duplex

:2 - 100Mbps Half Duplex

:3 - 10Mbps Full Duplex

:4 - 100Mbps Full Duplex

:5 - Auto

other - Quit

Step 6 Enter a number between 0 and 5, inclusive, representing the required option.

We recommend using 5 (Auto) and the ethernet switch port to autonegotiate speed/duplex. Step 7 Press any other key to quit without changing the network working mode.

Step 8 At the prompt, enter 4 to disable the DSP reset facility.

Note After options Q and 1-3, press any key to return to the video processing module Main menu. After option 4, the video processing module Main menu displays automatically.

Caution Only qualified technical personnel should modify the DSP reset function settings.

Modified network configuration settings are automatically saved when you exit the video processing module Main menu.

Procedure

Step 1 Ensure you have completed your configuration.

Step 2 At the prompt, enter Q to exit the video processing module Main menu.

The video processing module Main menu closes and your machine will automatically reboot.

Connecting the EMP to the LAN

Procedure

Step 1 Connect the supplied LAN cable from your network switch to the 10/100BaseT Ethernet port on the front panel of the EMP unit. The 10/100BaseT port accepts an RJ-45 connector.

We recommend setting the network switch port to auto-negotiate speed/duplex.

Step 2 Turn on the power to the EMP unit.

	Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU Release 5.6
2-12	OL-17012-01