Cisco Systems CB21AG Enabling Peap EAP-MSCHAP, Define Peap EAP-MSCHAP V2 Configuration Window

Chapter 5 Configuring the Client Adapter

Setting Security Parameters

Enabling PEAP (EAP-MSCHAP V2)

Follow the steps below to enable PEAP (EAP-MSCHAP V2) for this profile.

Step 1 Perform one of the following:

•If you want to enable PEAP (EAP-MSCHAP V2) without WPA or WPA2, choose 802.1x under Set Security Options and PEAP (EAP-MSCHAP V2) in the 802.1x EAP Type drop-down box.

•If you want to enable PEAP (EAP-MSCHAP V2) with WPA or WPA2, choose WPA/WPA2/CCKM under Set Security Options and PEAP (EAP-MSCHAP V2) in the WPA/WPA2/CCKM EAP Type drop-down box.

Note If you want to enable CCKM on the client adapter, you must choose the WPA/WPA2/CCKM security option, regardless of whether you want the adapter to use WPA or WPA2. The configuration of the access point to which your client adapter associates determines whether CCKM will be used with 802.1x, WPA, or WPA2.

Note Refer to the “WPA and WPA2” section on page 5-18for additional information.

Step 2 Click Configure. The Define PEAP (EAP-MSCHAP V2) Configuration window appears (see Figure 5-15).

Figure 5-15 Define PEAP (EAP-MSCHAP V2) Configuration Window

Cisco Aironet 802.11a/b/g Wireless LAN Client Adapters (CB21AG and PI21AG) Installation and Configuration Guide

5-46 OL-4211-03