Fujitsu Siemens Computers C2310 Serial/Parallel Port Configuration Submenu of the Advanced Menu

L i f e B o o k C S e r i e s N o t e b o o k B I O S

Serial/Parallel Port Configuration Submenu of the Advanced Menu

The Serial/Parallel Port Configuration submenu provides the ability to set the I/O addresses and inter- rupt levels for the serial (infrared) and parallel ports of your notebook.

I/O addresses, DMA channels, and Interrupt levels can be entered in various ways, including via the BIOS setup utility, the control software for the I/O device, or the hardware. If any two ports or devices have the same I/O address assigned, your notebook will not function normally.

•To prevent IRQ and address conflicts, avoid changing the default settings. If you must change the settings, you can call 1-800-8FUJITSU for technical assistance.

•The BIOS will warn you of a resource conflict by placing a yellow asterisk next to each device that is in conflict.

•All I/O addresses in Table 5 are in hexadecimal.

PhoenixBIOS Setup Utility

Advanced

	Serial/Parallel Port Configurations			Item Specific Help
Serial	Port:	Enabled		[Disabled]
I/O	Address:	[3F8	- 3FF]	The port is disabled.
Interrupt:		[IRQ 4]
Infrared Port:		[Enabled]		[Enabled]
Mode:		[FIR]		The port is enabled
I/O	Address:	[2E8	- 2EF]	with user configuration.
Interrupt:		[IRQ 3]
I/O	Address:	[400	- 43F]	[Auto]
DMA	Channel:	[DMA 3]		Plug & Play OS
Parallel Port:		[Enabled]		configure the port.
Mode:		[Bi-directional]
I/O	Address:	[378-37F]
Interrupt:		[IRQ 7]

F1 Help	Select	Item
ESC Exit	Select	Menu

-/Space	Change	Values
Enter	Select	▲ Sub-Menu

F9 Setup Defaults

F10 Save and Exit

Figure 5. Serial/Parallel Port Configuration Submenu

12