Power on Self Test Messages

fennec2.book Page 55 Thursday, December 21, 2006 12:43 PM

The following is an alphabetic list of error-and-status messages that Phoenix BIOS and/or your operating system can generate and an explanation of each message. Error messages are marked with an *. If an error message is displayed that is not in this list, write it down and check your operating system documentation both on screen and in the manual. If you can find no reference to the message and its meaning is not clear, contact your support representative for assistance.

nnnn Cache SRAM Passed

Where nnnn is the amount of system cache in kilobytes success-fully tested by the Power On Self Test. (This can only appear if you have an SRAM PC Card installed.)

*Diskette drive A error or Diskette drive B error

Drive A: or B: is present but fails the BIOS Power On Self Test diskette tests. Check to see that the drive is defined with the proper diskette type in the Setup Utility, (See BIOS Setup Utility on page 25 for more information) and that the diskette drive is installed correctly. If the disk drive is properly defined and installed, avoid using it and contact your support representative.

*Extended RAM Failed at offset: nnnn

Extended memory not working or not configured prop- erly. If you have an installed memory upgrade module, verify that the module is properly installed. If it is prop- erly installed, you may want to check your Windows Setup to be sure it is not using unavailable memory until you can contact your support representative.

nnnn Extended RAM Passed

Where nnnn is the amount of memory in kilobytes successfully tested.

*Failing Bits: nnnn The hex number nnnn

This is a map of the bits at the memory address (in System, Extended, or Shadow memory) which failed the memory test. Each 1 (one) in the map indicates a failed bit. This is a serious fault that may cause you to lose data if you continue. Contact your support representative.

*Fixed Disk x Failure or Fixed Disk Controller Failure (where x = 1-4)

The fixed disk is not working or not configured properly. This may mean that the hard drive type identified in your setup utility does not agree with the type detected by the Power On Self Test. Run the setup utility to check for the hard drive type settings and correct them if necessary. If the settings are OK and the message appears when you restart the system, there may be a serious fault which might cause you to lose data if you continue. Contact your support representative.

T r o u b l e s h o o t i n g

*Incorrect Drive A type – run SETUP

Type of floppy drive A: not correctly identified in Setup. This means that the floppy disk drive type identified in your setup utility does not agree with the type detected by the Power On Self Test. Run the setup utility to correct the inconsistency.

*Incorrect Drive B type – run SETUP

Type of floppy drive B: not correctly identified in Setup. This means that the floppy disk drive type identified in your setup utility does not agree with the type detected by the Power On Self Test. Run the setup utility to correct the inconsistency.

*Invalid NVRAM media type

Problem with NVRAM access. In the unlikely case that you see this message you may have some display prob- lems. You can continue operating but should contact your support representative for more information.

*Keyboard controller error

The keyboard controller test failed. You may have to replace your keyboard or keyboard controller but may be able to use an external keyboard until then. Contact your support representative.

*Keyboard error

Keyboard not working. You may have to replace your keyboard or keyboard controller but may be able to use an external keyboard until then. Contact your support representative.

*Keyboard error nn

BIOS discovered a stuck key and displays the scan code for the stuck key. You may have to replace your keyboard but may be able to use an external keyboard until then. Contact your support representative.

*Monitor type does not match CMOS – Run SETUP

Monitor type not correctly identified in Setup. This error probably means your BIOS is corrupted, run the setup utility and set all settings to the default conditions. If you still get this error, contact your support representative.

*Operating system not found

Operating system cannot be located on either drive A: or

drive C: Enter the setup utility and see if both the fixed

disk, and drive A: are properly identified and that the boot sequence is set correctly. Unless you have changed your installation greatly, the operating system should be on drive C:. If the setup utility is correctly set, your hard drive may be corrupted.

*Parity Check 1 nnnn

Parity error found in the system bus. BIOS attempts to locate the address and display it on the screen. If it cannot locate the address, it displays ????. This is a potentially data destroying failure. Contact your support representative.

A6020 specifications

The Fujitsu Siemens Computers A6020 is a desktop PC that exemplifies the combination of power and efficiency, catering primarily to small businesses and home office users. Launched in the early 2000s, it was designed to meet the growing demand for reliable computing solutions with a focus on affordability without compromising performance.

At its core, the A6020 is powered by a range of Intel processors, offering a variety of options to suit different user needs. Depending on the configuration, it can be equipped with Intel Pentium 4 or Intel Celeron processors, providing a solid balance of speed and efficiency for everyday tasks such as word processing, spreadsheets, and basic multimedia applications.

One of the standout features of the A6020 is its flexible expandability. With multiple expansion slots, users can easily upgrade their system to enhance performance, whether by adding more RAM or incorporating additional storage solutions. The machine typically supports up to 2GB of DDR memory, which was a considerable amount at the time, allowing users to run multiple applications simultaneously with ease.

In terms of storage, the A6020 comes with a variety of hard drive options, usually ranging from 40GB to 120GB. This ample capacity makes it suitable for users who need to store documents, presentations, and media files without immediate concern for running out of space. Moreover, the inclusion of optical drives gives users the capability to read and write CDs, a valuable function during an era where physical media was still prevalent.

Networking capabilities are also a key feature of the A6020. Equipped with Ethernet ports and optional wireless capabilities, it allowed users to easily connect to local networks and the internet, facilitating communication and data sharing in an increasingly digital workspace.

The design of the A6020 prioritizes user-friendliness, featuring a simple yet effective layout that allows for easy access to components and ports. The compact form factor ensures that it fits comfortably in various workspace environments, promoting efficient use of space.

Overall, the Fujitsu Siemens Computers A6020 represents a thoughtful combination of performance, expandability, and usability, making it a suitable choice for individuals and small businesses looking for a reliable desktop solution during its time in the early 2000s.