Cisco Systems AIRCAP1602EAK9, AIRCAP1602IAK9, AIRSAP1602IAK9, AIRSAP1602ITK9, AIRSAP1602EAK9 Models

Page 25

This device complies with Class B Limits of Industry Canada. Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.

Cisco Aironet Access Points are certified to the requirements of RSS-210. The use of this device in a system operating either partially or completely outdoors may require the user to obtain a license for the system according to the Canadian regulations. For further information, contact your local Industry Canada office.

This device has been designed to operate with antennas having a maximum gain of 6 dBi. Antennas having a gain greater than 6 dBi are strictly prohibited for use with this device. The required antenna impedance is 50 ohms.

To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (EIRP) is not more than that permitted for successful communication.

European Community, Switzerland, Norway, Iceland, and Liechtenstein

Models:

AIR-SAP1602I-E-K9

AIR-SAP1602E-E-K9

AIR-CAP1602I-E-K9

AIR-CAP1602E-E-K9

AIR-CLD1602I-E-K9

25

Image 25 Contents
Cisco Aironet 1600 Series Access Points About this Guide Introduction to the Access PointImportant Safety Instructions Safety InstructionsSuch use. Statement 245B UnpackingExternal Antennas ConfigurationsInternal Antennas Access Point Ports and ConnectorsRegulatory Domains Countries SupportedAntenna connector a Antenna connector C Antenna connector B Access Point LED Indicator top Controller Discovery Process Configuring the Access PointPage Installation Summary Preparing the Access PointPre-Installation Configuration Setup Performing a Pre-Installation ConfigurationPage Page Deploying the Access Point on the Wireless Network Mounting the Access PointUsing Dhcp Option TroubleshootingChecking the Access Point LED LED Troubleshooting the Access Point Join Process Page Models Declarations of Conformity and Regulatory InformationPage Vcci Statement for Japan 03-6434-6500 Industry Canada Statement 371-Power Cable and AC AdapterModels Page Page Generic Discussion on RF Exposure Declaration of Conformity for RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Chinese Translation English Translation Operation of Cisco Aironet Access Points in Brazil Portuguese Translation Declaration of Conformity StatementsCategory Specification Access Point SpecificationsObtaining Documentation and Submitting a Service Request Page Cisco Systems, Inc
Related manuals
Manual 38 pages 63.9 Kb Manual 52 pages 58.61 Kb