Cisco Systems AIRSAP1602ITK9, AIRCAP1602IAK9, AIRCAP1602EAK9 Important Safety Instructions

Page 3

802.11af/at

CDP (Cisco Discovery Protocol)

2.4 GHz and 5 GHz 802.11n radios with the following features:

3TX x 3RX

2 spatial streams, 300 Mbps PHY rate

DPD (Digital Pre-Distortion) technology

Radio hardware is capable of explicit compressed beamforming (ECBF) per 802.11n standard

3Safety Instructions

Translated versions of the following safety warnings are provided in the translated safety warnings document that is shipped with your access point. The translated warnings are also in the Translated Safety Warnings for Cisco Aironet Access Points, which is available on Cisco.com.

Warning

IMPORTANT SAFETY INSTRUCTIONS

Warning

Warning

Warning

This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents. Use the statement number provided at the end of each warning to locate its translation in the translated safety warnings that accompanied this device. Statement 1071

SAVE THESE INSTRUCTIONS

Read the installation instructions before you connect the system to its power source. Statement 1004

Installation of the equipment must comply with local and national electrical codes. Statement 1074

This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the protective device is rated not greater than:

20A. Statement 1005

3

Image 3
Contents Cisco Aironet 1600 Series Access Points About this Guide Introduction to the Access PointImportant Safety Instructions Safety InstructionsSuch use. Statement 245B UnpackingExternal Antennas ConfigurationsCountries Supported Access Point Ports and ConnectorsInternal Antennas Regulatory DomainsAntenna connector a Antenna connector C Antenna connector B Access Point LED Indicator top Controller Discovery Process Configuring the Access PointPage Installation Summary Preparing the Access PointPre-Installation Configuration Setup Performing a Pre-Installation ConfigurationPage Page Deploying the Access Point on the Wireless Network Mounting the Access PointTroubleshooting Using Dhcp OptionChecking the Access Point LED LED Troubleshooting the Access Point Join Process Page Models Declarations of Conformity and Regulatory InformationPage Vcci Statement for Japan 03-6434-6500 Industry Canada Statement 371-Power Cable and AC AdapterModels Page Page Generic Discussion on RF Exposure Declaration of Conformity for RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Chinese Translation English Translation Operation of Cisco Aironet Access Points in Brazil Portuguese Translation Declaration of Conformity StatementsCategory Specification Access Point SpecificationsObtaining Documentation and Submitting a Service Request Page Cisco Systems, Inc
Related manuals
Manual 52 pages 58.61 Kb