Cisco Systems 1602I Mounting the Access Point, Deploying the Access Point on the Wireless Network

Page 15

8Mounting the Access Point

Cisco Aironet 1600 series access points can be mounted in several configurations, including on a suspended ceiling, on a hard ceiling or wall, on an electrical or network box, and above a suspended ceiling. Click this URL to browse to complete access point mounting instructions:

http://www.cisco.com/en/US/docs/wireless/access_point/mounting/guide/apmount.html

9Deploying the Access Point on the Wireless Network

After you have mounted the access point, follow these steps to deploy it on the wireless network:

Step 1 Connect and power up the access point.

Step 2 Observe the access point LED (for LED descriptions, see “Checking the Access Point LED” section on page 16).

a.When you power up the access point, it begins a power-up sequence that you can verify by observing the access point LED. If the power-up sequence is successful, the discovery and join process begins. During this process, the LED blinks sequentially green, red, and off. When the access point has joined a controller, the LED is green if no clients are associated or blue if one or more clients are associated.

b.If the LED is not on, the access point is most likely not receiving power.

c.If the LED blinks sequentially for more than 5 minutes, the access point is unable to find its primary, secondary, and tertiary Cisco wireless LAN controller. Check the connection between the access point and the Cisco wireless LAN controller, and be sure the access point and the Cisco wireless LAN controller are either on the same subnet or that the access point has a route back to its primary, secondary, and tertiary Cisco wireless LAN controller. Also, if the access point is not on the same subnet as the Cisco wireless LAN controller, be sure that there is a properly configured DHCP server on the same subnet as the access point. See the “Using DHCP Option 43” section on page 16 for additional information.

Step 3 Reconfigure the Cisco wireless LAN controller so that it is not the Master.

Note A Master Cisco wireless LAN controller should be used only for configuring access points and not in a working network.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Cisco Aironet 1600 Series Access Points About this Guide Introduction to the Access PointImportant Safety Instructions Safety InstructionsSuch use. Statement 245B UnpackingExternal Antennas ConfigurationsCountries Supported Access Point Ports and ConnectorsInternal Antennas Regulatory DomainsAntenna connector a Antenna connector C Antenna connector B Access Point LED Indicator top Controller Discovery Process Configuring the Access PointPage Installation Summary Preparing the Access PointPre-Installation Configuration Setup Performing a Pre-Installation ConfigurationPage Page Deploying the Access Point on the Wireless Network Mounting the Access PointTroubleshooting Using Dhcp OptionChecking the Access Point LED LED Troubleshooting the Access Point Join Process Page Models Declarations of Conformity and Regulatory InformationPage Vcci Statement for Japan 03-6434-6500 Industry Canada Statement 371-Power Cable and AC AdapterModels Page Page Generic Discussion on RF Exposure Declaration of Conformity for RF ExposureThis Device Meets FCC Guidelines for Exposure to Radio Waves Additional Information on RF Exposure Chinese Translation English Translation Operation of Cisco Aironet Access Points in Brazil Portuguese Translation Declaration of Conformity StatementsCategory Specification Access Point SpecificationsObtaining Documentation and Submitting a Service Request Page Cisco Systems, Inc
Related manuals
Manual 52 pages 58.61 Kb
Top Page Image Contents