7-3 Cable wiring procedure in control panel
(1)Fixing of the cable
In order not to put any force on the cable and the
(2)Extra length of cable
Provide an extra length of the cable of 2 to 3 m inside a control panel for easier processing of the cable end and easier wiring when changing module positions.
Saddle
Saddle
An extra length of cable of 2 to 3 m
7
(3)Connection to the
The connector to the
(4)Insulation cover
When the connector touches with a high voltage section or external enclosures, communication errors may occur. Make sure to install an insulation cover.
Communication cable connection connector
"T" jacket
(insulation cover)
"L" jacket
(insulation cover)
(5)Grounding of power supply module
Make sure to use a
-If the power supply module is not grounded, the
When using a
| POWER | L | |
| Power input terminal for | ||
| INPUT | ||
| 85 to 132 VAC | ||
|
| N | |
SHORT | GND (ground) terminal | ||
grounding | GND | ||
| |||
|
| ||
| HALT |
| |
| OUTPUT |
| |
| Halt output terminal | ||
| (24VDC) | ||
|
| ||
| 1A |
|